User manual WHIRLPOOL WBC3735 A W PROGRAM CHART

[. . . ] After inserting food, ensure that the freezer compartment door closes properly. Control panel Anti-bacterial protection : 1. Filter in fan (depending on the model) 6. Crisper with antibacterial additives (depending on the model) 15. [. . . ] Note: • If food is placed in the refrigerator before the appliance has cooled completely, it may deteriorate. DEFROSTING THE FREEZER COMPARTMENT The freezer should be defrosted once or twice a year or when excessive frost is present (3 mm thickness). The amount and rate at which frost accumulates depends on room conditions and how often the door is open. To defrost the unit, switch off the freezer compartment or the whole appliance, depending on the model, and remove all food products. Leave the freezer door open to allow the frost to melt. For appliances in figure only pull out the defrost water drain and place a container under the drain. When the operation is completed, put back the defrost water drain. Switch the freezer compartment, or the whole appliance, back on and store the food inside. CONTROL PANEL DESCRIPTION (1) Cavity selection "Fridge / Freezer" pushbutton (2) Green lamp ON/OFF informing of: - freezer cabinet temp. setting (green lamp light ON) - fridge cabinet temp. setting - (green lamp light OFF) D GB F NL E P I GR S N DK FIN PL CZ SK H RUS BG RO PRODUCT SHEET DEFROSTING THE REFRIGERATOR COMPARTMENT Refrigerator compartment defrosting is completely automatic. Droplets of water on the rear wall inside the refrigerator compartment indicate that the automatic defrost phase is in progress. The defrost water is automatically run into a drain hole and collected in a container, where it evaporates. GB REPLACING THE LIGHT BULB Always disconnect the refrigerator from the power supply before replacing any light bulb. If the inside light is not working, it is necessary to: 1. Remove the light cover: put the fingers into the side ventilation holes (1), stretch the cover gently and move it upwards. If necessary unscrew the broken bulb and replace it with the new one (use maximum 15W bulb). Do not leave the bulb uncovered. GUIDE TO SELECTING FUNCTIONS Functions and settings Temperature setting button is used to select the fridge/freezer temperature set-point from among 5 levels (level 1, level 2, level 3, level 4, level 5) by consecutive pressing the button. Alarm deactivation - the user has to press Stand-by / Stop alarm pushbutton. Super Freezing: for more efficient freezing activate this function 24 hours before freezing fresh products. - Select Freezer compartment by using button (1), lamp (2) shall turn ON. - Press Temperature setting button until 3 green lamps light up simultaneously (4) (5) (6). After 24 hours place the food to be frozen in the upper basket of the freezer compartment. This function is automatically disabled after 24 hours. To deactivate it earlier follow the procedure: - Press the Temperature setting button again while the lamp (2) remains ON - the temperature selection lights will return to the 1st temperature level. [. . . ] After pressing the Stop alarm /stand-by mode button reset alarm , the beep will stop and the lamps will blink. To check the code alarm user have to press and hold the Temperature setting & stand-by pushbuttons and alarm code will be showing on the temperature lamps (possible alarm codes are explained in the table below). When this operation is released, the lamps will flash until the fault is eliminated. If any alarm shown in the table occurs, the fridge/freezer functions such as temperature adjustment, super freezing are not available until the fault is eliminated. [. . . ]