User manual WHIRLPOOL WBE 3623 NFS PROGRAM CHART

[. . . ] It is advisable to activate the fan when the ambient air temperature is over 27 ÷ 28°C or if you perceive drops of water on the glass shelves or in the severe humidity conditions. Note: Do not obstruct the air intake area with food items. The fan will run ONLY when the compressor is in operation. [. . . ] Filter in fan (depending on the model) 7. Crisper with antibacterial additives (depending on the model) 17. Door seals The crisper and the door seals are manufactured from materials that inhibit bacterial growth. Notes: - In case of power failure the cold accumulator helps to keep optimal storage temperature longer. - All shelves and door trays are removable. - The internal temperatures of the appliance depend on the ambient temperature, frequency of opening the doors, as well as location of the appliance. Temperature D GB F NL E P I GR S N HOW TO START THE APPLIANCE Fit the spacers (if supplied) on the upper part of the condenser at the rear of the appliance. After plugging the appliance to the mains, it starts the operation automatically. Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient. The indicator lamps on the control panel light up for approximately 1 second, and after initialization process, setpoint is displayed. Note: - If food is placed in the refrigarator before the appliance has cooled completely, it may deteriorate. - If fresh food is loaded in freezer position 3 on control panel should be chosen. CONTROL PANEL DESCRIPTION 1. 6. extra low temperature low temperature "ECO GREEN" position (depending on the model) high temperature temperature selection pushbutton internal light switch OPERATION DESCRIPTION Temperature adjustment is made with pushbutton (5). Temperature setpoint is done for both compartments at one time – fridge and freezer. DK FIN PL CZ SK H RUS BG RO PRODUCT SHEET At first plug-in of appliance factory setpoint is chosen – medium position (ECO Green, depending on model). Following table shows set-points level high temperature GB ABNORMAL APPLIANCE OPERATION When the product is plugged in to the mains, during first 10 minutes of its performance, possible temperature sensor failure will be displayed according to following table: Refrigerator sensor failure Freezer sensor failure low temperature extra low temperature Refrigerator freezer sensor failure Description Description Lamp OFF Lamp ON Lamp OFF Lamp Flashing GUIDE TO SELECTING FUNCTIONS Temperature selection pushbutton is used to set desired temperature level, from warmest through lower to coldest . Pressing pushbutton setpoint will change cyclically. Cooling off /Stand-by function This function turns off the refrigerator and freezer compartments. When the product is in this mode the light operates normally, all other loads are disabled and control panel shows no indication. [. . . ] The defrost water is automatically run into a drain hole and collected in a container, where it evaporates. REPLACING THE LIGHT BULB Always disconnect the refrigerator from the power supply before replacing any light bulb. If the inside light is not working, it is necessary to: 1. Remove the light cover: put the fingers into the side ventilation holes (1), stretch the cover gently and move it upwards. [. . . ]