User manual WHIRLPOOL WBE33252 NF TS PROGRAM CHART

[. . . ] After starting the appliance, wait at least 4-6 hours before placing food into the appliance. The indicator LEDs on the control panel light up for approximately 1 second, and after initialization process, setpoint is displayed. Note: - If food is placed in the refrigarator before the appliance has cooled completely, it may deteriorate. [. . . ] - The internal temperatures of the appliance depend on the ambient temperature, frequency of opening the doors, as well as location of the appliance. Temperature setting must consider these factors. - The appliance accessories are not suitable for washing in dishwasher. - After inserting food, ensure that the freezer compartment door closes properly. D GB F NL E P I GR S N DK FIN PL CZ SK H RUS BG RO UKR CA AE PRODUCT SHEET It is advisable to keep the fan active, if you perceive drops of water on the glass shelves or in the severe humidity conditions. Note: Do not obstruct the air intake area with food items. To guarantee the right performance at lower ambient temperature (colder than 18°C) and to minimize Energy Consumption, turn off the fan. To turn off the fan press the button (2a). If the appliance has the fan it can be equipped with the antibacterial filter. Remove it from the box (found in the crisper drawer (item 8) and insert into the cover of fan (item 2b). The replacement procedure is attached with the filter. CONTROL PANEL DESCRIPTION 1 2 3 4 Fast Cooling ON Fast Cooling OFF GB The Fast Cooling light ( yellow LED) will turn on. The function is automatically deactivated after 6 hours. The Fast Cooling function can be manually deactivated by pressing and holding the same pushbutton on the control panel for 3 sec. , the yellow LED is off. Note: - Fast Cooling function should be also switched ON before placing fresh food to be frozen in the freezer compartment, in order to maximize the freezing capacity. [. . . ] REPLACING THE LIGHT (depending on the model) BULB's LIGHTING Always disconnect the refrigerator from the power supply before replacing any light bulb. If the inside light is not working, it is necessary to: 1. Remove the light cover: put the fingers into the side ventilation holes (1), stretch the cover gently and move it upwards. [. . . ]