User manual WHIRLPOOL WBE3332 A NFCX PROGRAM CHART

[. . . ] Notes - In case of power failure the cold accumulator helps to keep optimal storage temperature longer. - All shelves and door trays are removable. - The internal temperatures of the appliance depend on the ambient temperature, frequency of opening the doors, as well as location of the appliance. Temperature setting must consider these factors. [. . . ] When the product is disconnected from the power supply and then reconnected, the control unit remembers previously set temperatures for freezer and refrigerator. FAN WITH A BUTTON The fan improves temperature distribution inside the refrigerator compartment, allowing better preservation of stored food. It is advisable to keep the fan active, so that the "Fresh Control" function can work and also when the ambient air temperature is over 27 ÷ 28°C or if you perceive drops of water on the glass shelves or in the severe humidity conditions. Note Do not obstruct the air intake area with food items. When Fresh Control is disabled remember to turn off the fan when there is a lower ambient air temperature. To turn off the fan press the button (1a). If the appliance has the fan it can be equipped with the antibacterial filter. Remove it from the box (found in the crisper drawer (item 7) and insert into the cover of fan (item 1b). The replacement procedure is attached with the filter. D GB F NL E P I GR S N DK FIN PL CZ SK H RUS BG RO PRODUCT SHEET DEFROSTING THE REFRIGERATOR COMPARTMENT Refrigerator compartment defrosting is completely automatic. Droplets of water on the rear wall inside the refrigerator compartment indicate that the automatic defrost phase is in progress. The defrost water is automatically run into a drain hole and collected in a container, where it evaporates. DEFROSTING THE FREEZER COMPARTMENT No Frost freezers provide chilled air circulation around the storage areas and prevent the formation of ice, thereby completely eliminating the need for defrosting. Frozen items don't stick to the walls, labeling stays legible and storage space remains neat and clear. REPLACING THE LIGHT BULB Always disconnect the refrigerator from the power supply before replacing any light bulb. If the inside light is not working, it is necessary to: 1. Remove the light cover: put the fingers into the side ventilation holes (1), stretch the cover gently and move it upwards. If necessary unscrew the broken bulb and replace it with the new one (use maximum 15W bulb). GUIDE TO SELECTING FUNCTIONS Functions and settings Fast Freezing: For more efficient freezing activate this function 48 hours before freezing fresh products. - Select Freezer compartment by using button (1), LED (2) shall turn ON. - Press and hold the temperature setting button Temp. °C until 3 green LEDs light up simultaneously (4) (5) (6). [. . . ] A short sound signal will be provided for the activation of the Fresh Control. This function controls the fridge fan in order to optimize food preservation in any ambient temperature conditions. To minimize the Energy consumption is suggested to disable the Fresh Control function and fan. OTHER ABNORMAL APPLIANCE OPERATIONS DISPLAYED BY LEDs In case of abnormal appliance operation, all the temperature selection LEDs will flash and one beep will sound. To check the code alarm user have to press and hold the temperature setting Temp. °C & Reset alarm pushbuttons and alarm code will be showing on the temperature LEDs (possible alarm codes are explained in the table below). [. . . ]