User manual WHIRLPOOL WBE34132 A WF PROGRAM CHART

[. . . ] The freezer compartment can be used without the two upper baskets to increase storage for large products. Place the food products directly on the racks. After inserting food, ensure that the freezer compartment door closes properly. Control panel Anti-bacterial protection : 1. [. . . ] - The internal temperatures of the appliance depend on the ambient temperature, frequency of opening the doors, as well as location of the appliance. Temperature setting must consider these factors. - The appliance accessories are not suitable for washing in dishwasher. HOW TO START THE APPLIANCE After plugging the appliance to the mains, it starts the operation automatically. The indicator lamps on the control panel light up for approximately 1 second, and after initialization process, setpoint is displayed. Note: • if food is placed in the refrigarator before the appliance has cooled completely, it may deteriorate. • If fresh food is loaded in freezer position 3 on control panel should be chosen. CONTROL PANEL DESCRIPTION low temperature extra low temperature Description Lamp OFF Lamp ON GUIDE TO SELECTING FUNCTIONS Temperature selection / stand-by pushbutton is used to set desired temperature level, from warmest through lower to coldest . Pressing pushbutton setpoint will change cyclically. Stand-by / ON function To put the appliance in Stand-by state press and hold Temperature selection / stand-by pushbutton for 3 seconds. Note: When the product is in stand-by mode the light operates normally, all other loads are disabled and control panel shows no indication. This prevents and reduces the proliferation of bacteria. An internal container, with an active carbon filtered ensures water filtration. To fill the tank: rotate the water inlet towards you and fill with water, using a jug or other suitable container. Once the tank is full, close the water inlet by moving it back to its original position. Always use drinking water only: any other liquid may impair product performance. Stop Water drip tray Fig. 2) After filling the tank, the water may not be immediately available. This is because the filtering process may require a few minutes (depending on the amount of water in the tank). To dispense water: with the refrigerator door closed, press the water dispenser tab with the glass. If for safety reason water delivery must be prevented, simply press the stop at the back of the tab. To release water delivery move the stop back to its original position. It is recommended to drink the supplied water from the dispenser in 6 hours. 3-4-5-6-7-8-9) Periodically clean the water tank with running water. [. . . ] Place the tank on a flat surface, remove and wash the top cover. Note: the tank must be refitted in its position as soon as possible, to prevent the refrigerator from overheating. Fig. 5a -5b) remove the internal container and the filter, and wash them separately. When washing the filter, only use clean water (no detergent or sharp tools). [. . . ]