User manual WHIRLPOOL WBE3621 A NFSMC PROGRAM CHART

[. . . ] Storage zones for frozen food items (basket or flap) 16a. "Eco green" basket (only in models with ECO GREEN function) 17. The freezer door trays for pizza or other frozen products with a short storage time (2*storage compartment) Anti-bacterial protection (depending on the model): - Antibacterial filter in the fan (1) - Antibacterial additives in the Crisper (7) - Door seals are made of material able to inhibit bacterial growth (17). Notes: - Depending on the model the number and type of accessories may vary. [. . . ] The net shelf is dishwashable. HOW TO START THE APPLIANCE Fit the spacers (if supplied) on the upper part of the condenser at the rear of the appliance. After plugging the appliance to the mains, it starts the operation automatically. After starting the appliance, wait at least 4-6 hours before placing food into the appliance. The indicator LEDs on the control panel light up for approximately 1 second, and after initialization process, setpoint is displayed. Note: - If food is placed in the refrigarator before the appliance has cooled completely, it may deteriorate. FIN PL CZ SK H RUS BG RO UKR CA PRODUCT SHEET FAN WITH A BUTTON The fan improves temperature distribution inside the refrigerator compartment, allowing better preservation of stored food. To switch on the fan press the button (1a). It is advisable to activate the fan when the ambient air temperature is over 27 ÷ 28°C or if you perceive drops of water on the glass shelves or in difficult humidity conditions. Note: Do not obstruct the air intake area with food items. The fan will run ONLY when the compressor is in operation. Remember to turn off the fan when there is a lower ambient air temperature. If the appliance has the fan it can be equipped with the antibacterial filter. Remove it from the box found in the crisper drawer (item 7) and insert into the cover of fan (item 1b). The replacement procedure is attached with the filter. Following table shows set-points level: High temperature Mid-high temperature (Eco Green) Middle temperature Mid-low temperature Low temperature GB Legend Led ON Led ON GUIDE TO SELECTING FUNCTIONS Fast Cooling The use of this function is recommended when placing a very high quantity of food in the refrigerator compartment By pressing and hold the pushbutton on the control panel for 3 sec. it is possible to increase the cooling speed of the foods inside the refrigerator compartment. CONTROL PANEL DESCRIPTION 1 2 3 4 1. Temperature selection / "Fast Cooling" (3sec. minimum) pushbutton 4. Internal light switch Fast Cooling ON Fast Cooling OFF TEMPERATURE SELECTION Press the pushbutton on the control panel to adjust the temperature. Temperature selection pushbutton is used to set desired temperature level, from warmest through lower to coldest . [. . . ] The defrost water is automatically run into a drain hole and collected in a container, where it evaporates. Legend Led ON Led ON REPLACING THE LIGHT (depending on the model) BULB's LIGHTING Always disconnect the refrigerator from the power supply before replacing any light bulb. If the inside light is not working, it is necessary to: 1. Remove the light cover: put the fingers into the side ventilation holes (1), stretch the cover gently and move it upwards. If necessary unscrew the broken bulb and replace it with the new one (max power of the light bulb is given on the light cover). [. . . ]