User manual WHIRLPOOL WBR 3512 S PRODUCT FICHE

[. . . ] Same as the last rinse and the final spin in the “Cotton” programme. in this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. [. . . ] ** Reference Programmes for Energy Label. *** Automatic adaption of programme duration after detection of wash load. Load the machine, close the drum doors and check that they are properly locked. Add detergent and eventual additives as described on the front page and in your Instructions for Use. Turn the programme selector to the desired programme and temperature. The lamp next to the “Start(Pause)” button blinks. The indication lamp of the predefined spin speed lights up. SELECT THE DESIRED OPTION(S) Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. €œPrewash” button • Only for heavily soiled loads (for example sand, granular dirt). Increases the cycle time by approximat ely 20 min. €¢ After the “Start(Pause)” button has been pressed, the number of hours preselected can be reduced by pressing again the “Start delay” button. to cancel the “Start delay” . Before you press the “Start(Pause)” button: • Turn the programme selector to another position or press the “Reset” button. After having pressed the “Start(Pause)” button: • Press the “Reset” button for at least 3 second. The start delay indicator light goes off. PROGRAMME START Open the tap and press the “Start(Pause)” button. The indication lamp next to the “Start(Pause)” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phrase is finised, the corresponding indication goes out. €¢ Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. €œDOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show the the lid can be opened. [. . . ] “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned: in the latter case refer to the Instructions for Use (“Removing the Filter”). PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. Turn the programme selector to the “Off/ O”position. [. . . ]