User manual WHIRLPOOL WCC31430AB INSTALLATION GUIDE

[. . . ] 7 cm) beyond the bottom of the cabinets. € It is recommended that all electrical connections be made by a licensed, qualified electrical installer. The cooktop must be a specified cooktop that is approved to be installed either alone or over an undercounter built-in oven. Check the cooktop base approved installation label for your cooktop model number and approved combinations of cooktops and ovens that can be installed. [. . . ] If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path and wire gauge are in accordance with local codes. Check with a qualified electrical installer if you are not sure the cooktop is properly grounded. Make sure that the electrical connection and wire size are adequate and in conformance with the National Electrical Code, ANSI/NFPA 70-latest edition or CSA Standards C22. A copy of the above code standards can be obtained from: National Fire Protection Association One Batterymarch Park Quincy, MA 02269 CSA International 8501 East Pleasant Valley Road Cleveland, OH 44131-5575 A D C L B E F G H I K J Before You Make the Electrical Connection: A. Combustible area above countertop (shown by dashed box above) C. 2 cm) minimum clearance between top of cooktop platform and bottom of uncovered wood or metal cabinet. 24" (61 cm) minimum clearance if bottom of wood or metal cabinet is covered by not less than ¹⁄₄" [0. 6 cm] flame retardant millboard covered with not less than No. 7 cm) minimum clearance from upper cabinet to countertop within minimum horizontal clearances to cooktop H. 5 cm) minimum distance to nearest left and right side combustible surface above cooktop L. 5 cm) minimum clearance between back wall and countertop To properly install your cooktop, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. NOTE: Make sure that the front edge of the cooktop is parallel to the front edge of the countertop. If repositioning is needed, lift entire cooktop up from cutout to avoid scratching the countertop. Mark on the countertop the location of the 4 mounting holes at the corners of the cooktop. – Push in the edge of coil element toward the receptacle. Then lift it enough to clear the burner bowl. Mounting holes ■ Pull the coil element straight away from the receptacle. Using 2 or more people, gently place the cooktop in cutout so that the cooktop mounting holes align with the 4 pilot holes. Attach the cooktop base to countertop with the 4 mounting screws. Reattach the cooktop to the cooktop base using the 4 screws. – Line up openings in the burner bowl with the coil element receptacle. Remove the 4 screws from inside each element opening and lift cooktop from cooktop base. [. . . ] 6 cm) 5 3-Wire Cable from Home Power Supply IMPORTANT: Use the 3-wire cable from power supply where local codes permit connecting the frame-ground conductor to the neutral (white) junction box wire. If there is an extra part, go back through the steps to see which step was skipped. Use a mild solution of liquid household cleaner and warm water to clean cooktop before use. For more information, see the “Cooktop Care” section of the Use and Care Guide. [. . . ]