User manual WHIRLPOOL WCC31430AW INSTALLATION GUIDE

[. . . ] section "Troubleshooting Guide"). When the temperature returns to within normal levels the hob is able to be switched on again. Make sure the cooking zones and the bottoms of pots are dry before use. Do not place metal objects such as kitchen utensils (knives, forks, spoons, . . . ), lids or other similar items on the cooking zones as they can become very hot. [. . . ] Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B). 70 mm of sheath from the power supply cable. Insert the power supply cable into the cable clamp and connect the wires to the terminal board as indicated in the diagram next to the terminal board itself. Secure the power cable with the cable clamp. Close the cover (C) and screw it on the terminal block with the removed screw - point (1). Each time the cooktop is connected to the mains it carries out an automatic check which lasts several seconds. DOMINO If the hob already has a power cable, follow the instructions given on the label attached to the cable. Connect the appliance to the electricity supply by means of an all-pole disconnect switch with minimum contact gap of 3 mm. A B C 77X35 400V 3N ~ 230V ~ 230-240V~FOR AU ONLY 230V~FOR UK ONLY 230V 230V 230V 230V 400V 2N ~ 230V 3~ ONLY FOR BELGIUM 400V 2N~ FOR NL ONLY 230V 230V 12 230V 230V 230V 230V 230V 31902052GB. fm Page 13 Wednesday, September 3, 2008 4:05 PM Installation and fixing WARNING!The installer is responsible for any damage or injury resulting from incorrect installation. To guarantee correct operation, the appliance must be installed on a perfectly flat surface. For cut-out dimensions, see the figure below. Domino 300 288 510 +1 0 The worktop must be -20 50mm thick. When switched on, the display shows level 5. Each cooking zone has different heat settings that can be adjusted using the buttons +/-, which go from "1": min. Some cooking zones have a fast boil function (Booster), shown on the display with the letter "P". Fast boil function (Booster) This function, only present on some cooking zones, makes it possible to exploit the hob's maximum power (for example to bring water to the boil very quickly). To select this function, press the button "+" until "P" appears on the display or, after switching the hob on, press the "-" button for the selected cooking zone. In this case too, "P" appears on the display. After 10 minutes' use of the booster function, the appliance automatically sets the zone to level 9. Switching off cooking zones Select the cooking zone to be switched off by pressing the "+" or "-" key (a dot lights up at the bottom right hand side of the heat setting indicator). Press the key "-" to set the level to "0". The cooking zone can also be switched off by pressing keys "+" and "-" at the same time. The cooking zone switches off and the residual heat indicator "H" lights up Minute minder The minute minder can only be used when the hob is not in use and allows a maximum setting of 99 min. Press the button "+" below the timer indicators: the display shows the minutes for setting. Select the time desired using the buttons + and -. [. . . ] A few seconds after the button is pressed, the timer begins the countdown (the luminous dot of the selected cooking zone starts flashing). Once the set time has elapsed, an acoustic signal sounds and the cooking zone switches off automatically. To deactivate the timer, press the button "-" until the display shows "0:0" or press the buttons "+" and "-" of the timer at the same time. Incorrect or missing pot indicator. The hob features an automatic pot detection system for all cooking zones. If no pot is detected, the display with the cooking zone power level indicator flashes. [. . . ]