User manual WHIRLPOOL WCF 17 PH INSTRUCTION FOR USE

[. . . ] Dispose of the appliance in conformity with local environmental regulations. Make the appliance unusable by cutting off the power cord. The appliance must be delivered to an authorised collection centre for the recovery of refrigerant gas. Information: This appliance does not contain CFCs (replaced with R134a) or HFCs (replaced with R600a Isobutane). [. . . ] Remove the external defrost water drain plug (depending on model) and reposition it as shown in figure (A). Place a bowl beneath the drainage channel to collect the residual water. Speed up defrosting by using a spatula to detach the ice from the freezer walls. Remove the ice from the bottom of the freezer. In order to avoid permanent damage to the freezer interior, do not use pointed or sharp metal instruments for removing the ice. Do not use abrasive products or heat up the interior artificially. • • • Dry the interior of the freezer compartment thoroughly. On completion of the defrosting, refit the plug. Switch on the appliance again. • • • A • • • • • B CARE AND MAINTENANCE To obtain the best results from your appliance, carry out cleaning and maintenance at least once a year. • • Remove the ice from the upper edge. Clean the inside after defrosting, using a sponge dampened with warm water and/or mild detergent. • Clean the motor cooling grille (depending on model). • Remove dust from the condenser on the rear of the appliance. Note: Before carrying out maintenance, unplug the appliance. Do not use abrasive products, scourers or stain-removers (e. g. acetone, trichloroethylene) to clean the appliance. 7 42007bGB. FM5 Page 8 Wednesday, September 27, 2000 3:28 PM TROUBLESHOOTING GUIDE 1. • Contents impeding correct closure of the freezer lid?• Appliance too near a source of heat?• Is the thermostat setting correct?• Are the ventilation grille and condenser clean?• Is the appliance in contact with other fixtures or items that could give rise to vibration?• Has the packaging been removed from under the freezer? [. . . ] Install the appliance in a dry, well ventilated room. Avoid locations near a source of heat or in direct sunlight. For optimum appliance operation and in order to avoid damage when the lid is opened, leave a space of at least 7 cm from the rear wall and 7 cm at the sides. Electrical connections must be made in accordance with local regulations. [. . . ]