User manual WHIRLPOOL WCG51US0DW INSTALLATION GUIDE

[. . . ] W10597144A COOKTOP SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] 6 Electrical Requirements Gas Supply Requirements WARNING WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Failure to follow these instructions can result in death, fire, or electrical shock. IMPORTANT: The cooktop must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22. If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate. A copy of the above code standards can be obtained from: National Fire Protection Association One Batterymarch Park Quincy, MA 02269 CSA International 8501 East Pleasant Valley Road Cleveland, Ohio 44131-5575 ■ A 120 volt, 60 Hz, AC only, 15-amp, fused electrical circuit is required. a time-delay fuse or circuit breaker is also recommended. It is recommended that a separate circuit serving only this cooktop be provided. If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column. examples of a qualified person include: licensed heating personnel , authorized gas company personnel , and authorized service personnel. Failure to do so can result in death, explosion, or fire. observe all governing codes and ordinances. IMPORTANT: This installation must conform with all local codes and ordinances. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223. 1 - latest edition or CAN/CGA B149 - latest edition. IMPORTANT: Leak testing of the cooktop must be conducted according to the manufacturer’s instructions. Type of Gas Natural Gas: This cooktop is design-certified by CSA International for use with Natural gas or, after proper conversion, for use with LP gas. – This cooktop is factory set for use with Natural gas. If converting to LP gas, see the “LP Gas Conversion” instructions provided in the package containing literature. The model/serial rating plate located on the underside of the cooktop base has information on the types of gas that can be used. If the types of gas listed do not include the type of gas available, check with the local gas supplier. LP Gas Conversion: Conversion must be done by a qualified service technician. No attempt shall be made to convert the cooktop from the gas specified on the model/serial rating plate for use with a different gas without consulting the serving gas supplier. [. . . ] The surface burner “low” flame should be a steady blue flame approximately ¼" (6. Failure to follow these instructions can result in death, fire, or electrical shock. Complete Installation Electronic Ignition System Initial lighting and gas flame adjustments Surface burners use electronic igniters in place of standing pilots. When the cooktop control knob is turned to the “IGNITE” position, the system creates a spark to light the burner. [. . . ]