User manual WHIRLPOOL WD 140 IX INSTRUCTION FOR USE

[. . . ] • The appliance becomes very hot during use. Be careful not to touch the heating elements inside the warming drawer. • The warming drawer is only intended for domestic use, for heating food or dishes (depending on the model). The Manufacturer declines any liability for improper use or incorrect setting of the controls. [. . . ] The data must match, otherwise the appliance could become damaged. In case of doubt, contact a qualified technician. Make sure the socket can be easily accessed even after the appliance has been fitted. The dish warmer can only be fitted in combination with other appliances not weighing more than 40 kg and provided with adequate cooling ventilation. Otherwise, the right to the warranty is invalidated, since correct use cannot be guaranteed. For combined appliance installation comply with the instructions given in the relevant use and installation handbook. Fitting and installation of this appliance must only be carried out by qualified personnel who guarantee that the requirements for safe use are met. Important: The coffee machine or the combined microwave oven, of size according to the figure on the next page and same brand, can be installed on top of the 140 drawer. For installation, carefully follow the instructions given in the handbooks supplied with the coffee machine and the combined microwave oven. Recess measurements The dimensions of the recess are obtained from the size of the dish warmer plus the size of the appliance combined with it. All measurements are given in mm. 103 Height 140 mm Height 290 mm 104 ELECTRICAL CONNECTION Contact a qualified technician to carry out the appliance electrical connection. Important: Before connecting the drawer to the domestic power supply to check its operation, always make sure the drawer power cable is correctly fitted and NOT squashed or caught under or behind the drawer or a combined appliance. Important: Power cable replacement must be made with a cable having the same characteristics as that supplied by the Manufacturer (type H05RR-F, 3x1 mm2 or higher) and carried out by the After-Sales Service or a qualified technician. Before connecting the appliance to the power supply, make sure that the technical specifications (voltage: V and frequency: Hz) given on the rating plate match those of the power mains. In case of doubt, contact a qualified technician. If the plug is removed from the power cable, contact a qualified technician for fitting and connecting the appliance. Contact an electrician aware of the local regulations and the electricity company's regulations, ensuring that the work is carried out in compliance with the same. Important: Make sure the appliance is connected to an approved earth wire, to guarantee electrical safety. If necessary, have the system checked by a specialised technician. The Manufacturer declines any liability for injury and damage due to the lack or interruption of the earth wire. Important: The earth connection is compulsory by law. If the appliance is connected to the power supply by means of an extension cord, make sure the cord and connection are insulated against moisture. The appliance is designed to be used only when correctly fitted. In case of contact with live wires or if the electrical and mechanical structure of the appliance is modified, an appliance fault may occur when it is used. [. . . ] • Use a clean cloth, absorbent paper and dish hand-wash detergent, or specific products for cleaning the vitroceramic top. • Remove stubborn cooking grime with specific products. Always specify: • a brief description of the fault; • the type and exact model of the warming drawer; • the Service number (number after the word Service on the rating plate), located on the outer right edge of the drawer slide. The service number is also indicated on the guarantee booklet; • your full address; • your telephone number. If any repairs are required, contact an authorised After-Sales Technical Service (to guarantee the use of original spare parts and correct repair). [. . . ]