User manual WHIRLPOOL WDE350LVB DIMENSION GUIDE

[. . . ] You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. WARNING Tip Over Hazard A child or adult can tip the range and be killed. Connect anti-tip bracket to rear range foot. Reconnect the anti-tip bracket, if the range is moved. Failure to follow these instructions can result in death or serious burns to children and adults. 2 INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. [. . . ] O-M91-latest edition, and all local codes and ordinances. A copy of the above code standards can be obtained from: National Fire Protection Association One Batterymarch Park Quincy, MA 02269 CSA International 8501 East Pleasant Valley Road Cleveland, OH 44131-5575 A B C D E H F Electrical Connection G To properly install your range, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. Range must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model/serial number rating plate is located below the electronic control on oven frame. See the following illustration. I A. For minimum clearance to the top of the cooktop, see NOTE*. 23¹/" (58. 1 cm) opening depth E. from either cabinet, 8¹/" (21 cm) max. Cabinet door or hinge should not extend into cutout. 27¹/" (69. 9 cm) top of countertop to support slats I. 6" (15. 2 cm) wide support slat on each side of cutout A NOTE: 24" (61. 0 cm) minimum when bottom of wood or metal cabinet is protected by not less than ¹/" (0. 64 cm) flame retardant millboard covered with not less than No. Use an adjustable wrench to loosen the leveling legs. Place cardboard or hardboard in front of range. Using 2 or more people, stand range back up onto cardboard or hardboard. B A. Drill two ¹/" (3. 0 mm) holes that correspond to the bracket holes of the determined mounting method. See below. A B Install Anti-Tip Bracket 1. Remove the anti-tip bracket that is taped in the oven cavity. Determine and mark centerline of the cutout space. The mounting bracket can be installed on either the left side or right side of the cutout. Position mounting bracket in cutout so that right (or left) edge of the bracket is 13¾" (34. 9 cm) from centerline, as shown. A. Using the Phillips screwdriver, mount anti-tip bracket to the support slat with the two #12 x 1/" screws provided. 5 Adjust Leveling Legs 1. If range height adjustment is necessary, use a wrench or pliers to loosen the 4 leveling legs. [. . . ] A minimum of ³/" (5. 0 mm) is needed to engage the anti-tip bracket. NOTE: If height adjustment is made when range is standing, tilt the range back to adjust the front legs, then tilt forward to adjust the rear legs. When the range is at the correct height, check that there is adequate clearance under the range for the anti-tip bracket. Before sliding range into its final position, check that the antitip bracket will slide under the range and onto the rear leveling leg prior to anti-tip bracket installation. A A. [. . . ]