User manual WHIRLPOOL WDF310PLAB USE & CARE GUIDE

[. . . ] • • This appliance is designed for use in the home in compliance with its intended purpose. All water and electrical connections must be carried out by a qualified technician in compliance with the manufacturer's instructions (refer to the enclosed installation booklet) and current local safety regulations. • PROTECTING THE ENVIRONMENT 1. Packing The packing box may be fully recycled as confirmed by the recycling symbol . Appliance The appliance is built from reusable materials. [. . . ] If crockery is prone to whitish streaks, reduce the dosage by turning the dial to a lower setting. If instead crockery is wet, increase the dosage by turning the dial to a higher setting. Rinse aid level indicator (visual or electric indicator depending on the model installed). Electric indicator: The indicator lamp on the control panel illuminates when the rinse aid dispenser is empty. Visual indicator: light= empty dark= full. 15 HOW TO FILL THE DETERGENT DISPENSER Only use detergents recommended for use in domestic dishwashers. If you use “new generation” enzyme-based detergents, select the Bio programmes which are also suitable for all normal detergents. If you use detergents in pellet form, follow the manufacturer's directions for use. Always use the recommended dosage stated on the detergent pack. The use of detergent in excess of the recommended dosage may cause pollution. The recommended dosage varies between different brands. The figures inside the large compartment serve as a dosage guide. The figures are in “ml” or “cm 3”. Only fill the detergent dispenser prior to starting a wash programme. The selected programmes are also saved in the event of power failure. To change the programme selected, press the Start button for about 5 seconds until the Start indicator lamp switches off. Click out the programme selector knob, select the new programme and press the Start button. The End indicator lamp (if fitted) illuminates briefly and the Start indicator lamp switches off to indicate the end of the programme. Click out the programme selector knob to switch off the dishwasher. Turn the programme selector knob anticlockwise. to the “0” position (only after the End indicator lamp has switched on or the Start indicator lamp has switched off). Note: If the dishwasher is switched off during a wash programme when switched on again the dishwasher resumes the wash cycle from where it was interrupted. Open the door and unload first the lower rack and then the upper one. 17 1 2 3 4 5 CONNECTIONS Refer to the separate installation instructions booklet. Water inlet and drain: • Strictly follow local Water Board regulations. • Make sure the inlet and drain hoses are kinkfree and are not crushed. [. . . ] approved type conforming to BS 1362 and proceed as follows: 2) CONNECTION TO A REWIRABLE PLUG - to be carried out only by a qualified electrician The wires in the mains lead are coloured in accordance with the following code: BLUE - “NEUTRAL” (“N”) BROWN - “LIVE” (“L”) GREEN AND YELLOW - “EARTH” (“E”) To fit a new plug, proceed as follows: 2. 1 Polarized Plugs (e. g. 3 pin, 13 amp plug conforming to BS 1363A) a. The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter “E” or by the Earth symbol or coloured yellow or green and yellow. The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured black. [. . . ]