User manual WHIRLPOOL WDF550SAAS INSTALLATION GUIDE

[. . . ] Models/Modèles WDF550SAAW WDF550SAAB WDF550SAAS W10518038 DISHWASHER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] nOTE: The copper tubing will bend and kink easily. The copper tubing should be far enough into the cabinet opening to connect it to the dishwasher inlet on the front lefthand side of the dishwasher. Run water into a shallow pan to flush the copper tubing of particles that may clog the inlet valve. Drain trap Connect Drain Hose to Air Gap—No Waste Disposal IMPORTANT: Always use a new drain hose even when installing a new replacement dishwasher. 8 cm) diameter hole in the cabinet wall or floor on the side of the opening closest to the sink. - Connect Drain Hose to Air Gap—Waste Disposal IMPORTANT: Always use a new drain hose even when installing a new replacement dishwasher. 8 cm) diameter hole in the cabinet wall or floor on the side of the opening closest to the sink. Cut the end of the drain hose, if needed. Cut the end of the drain hose, if needed. Attach the drain hose to the air gap with the large spring-type clamp. NOTE: If the drain hose was cut, use 1¹⁄₂" to 2 " (3. Extend leveling legs out from the dishwasher base, ¹⁄₄" less than the shortest opening height. Using 2 or more people, place the dishwasher on its back on a piece of cardboard. Using a Phillips screwdriver, remove the 4 screws attaching the toekick panel and lower panel to the dishwasher. Leveling leg A Check Door Spring Tension WARNING Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. Using 2 or more people, place the dishwasher upright in front of cabinet opening. With one person holding the dishwasher to avoid tipping, open and close the dishwasher door a few times. If the door closes too quickly or falls open under its own weight, adjust the tension. – If the door closes too quickly, decrease the spring tension by pulling the spring adjustment pin out of its hole and reinsert it into the next lower hole toward the back of the dishwasher. NOTE: Elbow should face to the rear of the dishwasher. A ■ If the door falls open, increase the spring tension by pulling the spring adjustment pin out of its hole and reinserting it into the next higher hole toward the top of the dishwasher. [. . . ] Check that the top of the door does not contact the screws, brackets or countertop. If it does, the dishwasher must be lowered and leveled again. Connect the drain hose to the air gap, waste tee or disposal with clamps. 13 `Method 2 When countertops are granite or other materials that will not accept screws, secure dishwasher with sidemounting brackets. [. . . ]