User manual WHIRLPOOL WDL785SAAM DIMENSION GUIDE

[. . . ] All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. € These words mean: DANGER WARNING You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. [. . . ] If the drain hose was cut, use a 1¹⁄₂" to 2" (3. Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from waste tee to air gap. Remove and discard the foam blocks located above the front legs on each side of the dishwasher. The blocks cover the rope/link pulleys on the dishwasher. Helpful Tip: Place cardboard under dishwasher until installed in cabinet opening to avoid damaging floor covering. Do not use door panel as a worktable without first covering with a towel to avoid scratching the door panel. 11 Using two or more people, grasp sides of dishwasher door frame and place dishwasher on its back. Using a ¹⁄₄" hex head socket, nut driver or Torx® T20® screwdriver, remove terminal box cover. Remove and discard the plastic rail cover on each side of the dishwasher frame. To remove the plastic rail cover, push upward and back to unsnap it from the dishwasher frame. install a UL Listed/CSA Approved strain relief. Wheels and legs are preset at the factory for 34¹⁄₂" [87. Close cover ensuring wires are not pinched. Use ¹⁄₄" hex-head socket, nut driver or Torx® T20® screwdriver and previously removed screw to secure cover. NOTE: Do not plug into outlet until instructed to do so. Turn both leveler legs to the same height. Put wheels in the required position determined from “Dishwasher Height Adjustment Chart. € 14 Option A, Countertop Attachment Built-up floors: If the kitchen floor is higher than the cabinet opening's floor - for example, the kitchen floor tile does not extend into the cabinet opening - add shims as needed in the area shown to bring the dishwasher up to 34" (86. NOTE: Shims must be securely attached to floor to avoid movement when the dishwasher is in use. Remove the brackets from the package and insert into the open slots on the left and right-hand top of the dishwasher collar as shown. Failure to do so can result in back or other injury. NOTE: Do not install kick plate until instructed to do so. [. . . ] Check that the lower edge of the access panel touches the floor. Check that power supply cord does not touch dishwasher motor or lower part of dishwasher tub. Reconnect Power Using a flat-blade screwdriver, turn the fasteners ¹⁄₄ turn clockwise to lock into place. The fasteners slot will be straight up and down when properly locked. [. . . ]