User manual WHIRLPOOL WED4890BQ INSTALLATION GUIDE

[. . . ] ELECTRIC DRYER INSTALLATION INSTRUCTIONS 29" WIDE MODELS – U. S. A. ONLY Para obtener acceso al manual de uso y cuidado en español, o para obtener información adicional acerca de su producto, visite: www. whirlpool. com Tenga listo su número de modelo completo. Puede encontrar el número de modelo y de serie dentro de la cavidad superior de la puerta. Table of Contents DRYER SAFETY. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 INSTALLATION REQUIREMENTS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] For 4 wire Direct Wire Connection, continue to step 3 below. 5. Connect remaining wires 4-wire Direct Wire Connection IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit 3-wire connections. 3. Prepare your 4-wire cable for direct connection Connect remaining wires to outer terminal block screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Now, go to “Venting Requirements. ” (25 m 1" m) Direct Wire Connection Direct wire strain relief 5 (127 " mm ) 1. Attach direct wire strain relief A Direct wire cable must have 5 ft. (1. 52 m) of extra length so dryer may be moved if needed. Strip 5" (127 mm) of outer covering from end of cable, leaving bare ground wire at 5" (127 mm). Cut 11/2" (38 mm) from remaining 3 wires. Shape ends of wires into hooks. B C 4. Connect wires to terminal block Unscrew the removable conduit connector (A) and any screws from a 3/4" (19 mm) UL listed strain relief (UL marking on strain relief). Put the threaded section of the strain relief through the hole (B) below the terminal block opening. Reaching inside the terminal block opening, screw the removable conduit connector onto the strain relief threads (C). To connect wires to terminal block, place hooked end of wire under terminal block screw (facing to the right), squeeze hooked end together, and tighten screw. 10 5. Prepare to connect neutral ground wire and neutral wire 8. Connect remaining wires A B E Remove center terminal block screw (B). Remove neutral ground wire (E) from external ground conductor screw (A). Place hooked ends of remaining direct wire cable wires under outer terminal block screws (hooks facing right). Squeeze hooked ends together and tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Now, go to “Venting Requirements. ” 3-wire Direct Wire Connection Use where local codes permit connecting cabinet-ground conductor to neutral wire. 6. Connect neutral ground wire and neutral wire 3. Prepare your 3-wire cable for direct connection C B 3½" (89 m m) 1" m) 25 m ( E Connect neutral ground wire (E) and place hooked end (hook facing right) of neutral wire (white or center wire) (C) of direct wire cable under center screw of terminal block (B). Squeeze hooked ends together and tighten screw. Direct wire cable must have 5 ft. [. . . ] Holding door over towel on dryer, grasp sides of outer door and lift to separate it from inner door. NOTE: Do not pry apart with putty knife or screwdriver. Do not pull on door seal or plastic door catches. 17 6. Switch door catch, bezel, & plug Catch and bezel Plug 8. [. . . ]