User manual WHIRLPOOL WED8510FW DIMENSION GUIDE

[. . . ] Gas and Electric Dryer PRODUCT MODEL NUMBERS WED8000D, WED8500D, WGD8000D, WGD8500D, WED8700E, WGD8700E, WED8510F Side view 561/4" (1428 mm) 3213/16" (821 mm) Door Opened Door Closed Back view 29" (737 mm) 57/8" (150 mm) 4213/16" (1987 mm) 41/2" (115 mm) 3" (77 mm) 13/8" 141/2" (35 mm) (370 mm) 31/2" (93 mm) 1" (25 mm) 113/8" 35/8" (289 mm) (93 mm) NOTE: Leveling legs 1" (25 mm) (3. 6 washer capacity) or 1½" (38 mm) (3. 8 washer capacity) depending model. Bottom view Minimum Required Spacing 14" max (356 mm) 81/2" (218 mm) 143/8" (365 mm) NOTE: Most installations require a minimum of 6" (152 mm) clearance behind dryer for exhaust vent with elbow. [. . . ] Pipe-joint compounds resistant to the action of L. P. An individual manual shutoff valve must be installed within 6 ft (1. 8 m) of the dryer in accordance with the National Fuel Gas Code ANSI Z223. 1. ELECTRICAL REQUIREMENTS - Gas models only A 120-volt, 60 Hz, AC-only, 15 or 20 amp fused electrical supply is required. A time-delay fuse or circuit breaker and a separate circuit are recommended. ELECTRICAL REQUIREMENTS - Electric models only To supply the required 3 or 4 wire, single phase, 120/240 volt, 60 Hz. , AC only electrical supply (or 3 or 4 wire, 120/208 volt electrical supply, if specified on the serial/rating plate) on a separate 30-amp circuit, fused on both sides of the line. A time-delay fuse or circuit breaker is recommended. Connect to an individual branch circuit. WATER (STEAM MODELS ONLY) REQUIREMENTS The dryer must be connected to the cold water faucet using new inlet hoses. Damage to the coupling can result. VENTING REQUIREMENTS Exhaust venting: Exhaust your dryer to the outside. 4" (102 mm) diameter vent is required. Rigid or flexible metal exhaust vent must be used. [. . . ] Specifications subject to change without notice. [. . . ]