User manual WHIRLPOOL WED9290FW INSTALLATION GUIDE

[. . . ] Com INSTALLATION NOTES Date of purchase:__________________________________ Date of installation:________________________________ Installer:_________________________________________ Model number:____________________________________ Serial number:____________________________________ NOTES CONCERNANT L’INSTALLATION Date d’achat :______________________________________ Date d’installation :_________________________________ Installateur :_______________________________________ Numéro de modèle :_________________________________ Numéro de série :___________________________________ W10777574B W10777575B - SP Dryer Safety Certain internal parts are intentionally not grounded and may present a risk of electric shock only during servicing. Service Personnel – Do not contact the thermostat bracket while the appliance is energized. 2 Installation Requirements TOOLS AND PARTS Gather the required tools and parts before starting installation. Parts supplied: Tools needed: Leveling legs (4) Flat-blade screwdriver #2 Phillips screwdriver 6' (1829 mm) drain hose with couplers Cable ties (2) Wire stripper (direct wire installations) Channel locks Parts package is located in dryer drum. [. . . ] If your outlet looks like this: Power supply cord 4-wire receptacle (NEMA Type 14-30R): Go to “4-Wire Power Supply Cord Connection. € A B C D 4-Wire Power Supply Cord Connection IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit the use of 3-wire connections. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Tighten strain relief screw against the direct wire cable. If your wiring looks like this: 4-wire direct connection: Go to “4-Wire Direct Wire Connection. € Remove center terminal block screw (B). Remove neutral ground wire (E) from green external ground conductor screw (A). € E C 4-Wire Direct Wire Connection IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit 3-wire connections. Prepare your 4-wire cable for direct connection 31 ⁄2" ) m (89 m 1" ) m (25 m Connect neutral ground wire (E) and place hooked end (hook facing right) of neutral wire (white or center wire) (C) of direct wire cable under center screw of terminal block (B). Connect ground wire Direct wire cable must have 5 ft. 52 m) of extra length so dryer may be moved if needed. Strip 5" (127 mm) of outer covering from end of cable, leaving bare ground wire at 5" (127 mm). Cut 11/2" (38 mm) from remaining 3 wires. A F Connect ground wire (green or bare) (F) of direct wire cable under green external ground conductor screw (A). Connect neutral wire B C Place hooked ends of remaining direct wire cable wires under outer terminal block screws (hooks facing right). squeeze hooked ends together and tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. € Place hooked end of neutral wire (white or center) (C) of direct wire cable under center terminal block screw (B), hook facing right. Prepare your 3-wire cable for direct connection 1" ) m (25 m 3½ (89 m " m) Direct wire cable must have 5 ft. 52 m) of extra length so dryer may be moved if needed. If using 3-wire cable with ground wire, cut bare wire even with outer covering. Place hooked ends of remaining direct wire cable wires under outer terminal block screws (hooks facing right). [. . . ] Rotate the outer window assembly counterclockwise to lock tabs into place (figure B). Using a Phillips screwdriver, secure with 2 screws removed earlier. B Using a Phillips screwdriver, remove the 4 screws from the outer window retainer and lift off the trim ring off the window (A). Rotate trim ring 180° and secure with the 4 screws removed earlier (B). [. . . ]