User manual WHIRLPOOL WED9470WR

[. . . ] For questions about features, operation/performance, parts, accessories, or service, call: 1-800-253-1301 or visit our website at. " It may save you the cost of a service call. If you still need help, follow the instructions below. When calling, please know the purchase date and the complete model and serial number of your appliance. [. . . ] NOTE: If you do not press Start within 5 minutes of selecting the cycle, the dryer automatically shuts off. NOTE: When the WRINKLE SHIELDTM feature is selected and the End of Cycle Signal is on, an audible sound will be emitted every 5 minutes until the clothes are removed, or the WRINKLE SHIELDTM feature is finished. You can change an Option or Modifier anytime before the selected Option or Modifier begins. NOTE: If you happen to press Pause/Cancel twice, the program clears and your dryer shuts down. You can change the volume of the sound of the beeps. If all your loads on all Auto Dry cycles are consistently not as dry as you would like, you may change the preset Dryness Level settings to increase the dryness. This change will affect all of your Auto Dry cycles. Your Dryness Level settings can be adjusted to adapt to different installations, environmental conditions or personal preference. There are 3 drying settings: 1 (factory preset dryness level), 2 (slightly drier clothes, approximately 15% more drying time), and 3 (much drier clothes, approximately 30% more drying time). The Dryness Level settings cannot be changed while the dryer is running. To select a new drying setting, press the Dryness Level key again until the desired drying setting is shown. NOTE: While cycling through the settings, the current setting will not flash, but the other settings will flash. The drying setting you selected will become your new preset drying setting for all Auto Dry cycles. This feature allows you to lock your settings to avoid unintended use of the dryer. You can also use the Control Lock feature to avoid unintended cycle or option changes during dryer operation. The control is locked when a double beep is heard and the Control Lock status light is on. When the dryer is off, it is not necessary to press the Control On button before activating the Control Lock feature. Press and hold the CONTROL LOCK/UNLOCK button for 3 seconds to turn this feature off. NOTE: When the dryer is running and Control Lock is on, the dryer can be stopped by pressing the Pause/Cancel button, but cannot be restarted until the control is unlocked. Clean the lint screen with a nylon brush every 6 months, or more frequently, if it becomes clogged due to a residue buildup. Roll lint off the screen with your fingers. Wet both sides of lint screen with hot water. [. . . ] Service calls to correct the installation of your major appliance, to instruct you on how to use your major appliance, to replace or repair house fuses, or to correct house wiring or plumbing. Service calls to repair or replace appliance light bulbs, air filters or water filters. Consumable parts are excluded from warranty coverage. Damage resulting from accident, alteration, misuse, abuse, fire, flood, acts of God, improper installation, installation not in accordance with electrical or plumbing codes, or use of products not approved by Whirlpool. [. . . ]