User manual WHIRLPOOL WFC 3C26 P X GUIA DE SAÚDE, SEGURANÇA E INSTALAÇÃO

[. . . ] Do not store explosive or flammable substances such as aerosol cans and do not place or use gasoline or other flammable materials in or near the appliance: a fire may break out if the appliance is inadvertently switched on. This appliance is intended to be used in household and similar applications such as: • staff kitchen areas in shops, offices and other working environments; • farm houses; • by clients in hotels, motels and other residential type environments; • bed and breakfast type environments. The appliance must be used only to wash domestic crockery in accordance with the instructions in this manual. The water supply tap must be shut off and the plug should be removed from the electrical socket at the end of every cycle and before cleaning the appliance or carrying out any maintenance work. [. . . ] The inlet water temperature depends on the dishwasher model. If the installed inlet hose is marked "25°C max", the For all other models the maximum allowed water temperature is 60°C. Do not cut hoses and, in the case of appliances fitted with a waterstop system, do not immerse the plastic casing containing the inlet hose in water. If hoses are not long enough, contact your local dealer. Make sure the inlet and drain hoses are kink-free and are not crushed. Before using the appliance for the first time, check the water inlet and drain hose for leaks. During use, the access to the rear wall should be limited in a sustainable manner such as approaching the device to the wall or furniture board. When installing the appliance make sure that the four feet are stable and resting on the floor, adjusting them as required, and check that the appliance is perfectly levelled using a spirit level. If installing the appliance at the end of a row of units making the side panel accessible, the hinge area must be covered to prevent risk of crushing. For dishwashers having ventilation openings in the base, the openings must not be obstructed by a carpet. ELECTRICAL WARNINGS For installation to comply with current safety regulations, an omnipolar switch with minimum contact gap of 3mm is required and the appliance must be earthed. If the power cable is damaged, replace with an identical one. The power cable must only be Replaced by a qualified technician in compliance with the manufacturer instruction and current safety regulations. If the fitted plug is not suitable for your socket outlet, contact a qualified technician. The power cable must be long enough to connect the appliance, once fitted in its housing, to the main power supply. do not use extension leads , multiple sockets or adapters. Do not operate this appliance if it has a damaged mains cord or plug, if it is not working properly, or if it has been damaged or dropped. The electrical components must not be accessible to the user after installation. Do not touch the appliance with any wet part of the body and do not operate it when barefoot. CORRECT USE The water in the dishwasher is not potable. The maximum number of place settings is shown in the product sheet. The door should not be left in the open position since this could present a tripping hazard. [. . . ] SCRAPPING OF HOUSEHOLD APPLIANCES When scrapping the appliance, make it unusable by cutting off the power cable and removing the doors and shelves (if present) so that children cannot easily climb inside and become trapped. This appliance is manufactured with recyclable or reusable materials. Dispose of it in accordance with local waste disposal regulations. For further information on the treatment, recovery and recycling of household electrical appliances, contact your competent local authority, the collection service for household waste or the store where you purchase the appliance. [. . . ]