User manual WHIRLPOOL WFC130M0AW DIMENSION GUIDE

[. . . ] 10 General Care & Cleaning . . . . . . . . 11-13 Before You Call Solutions to Common Problems . . . . . . . . . . . . . . . . . . . . . . . . 14 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . Back Page Questions or for Service Call: 1-800-944-9044 (U. S. ) 1-800-668-4606 (Canada) READ AND SAVE THESE INSTRUCTIONS p/n 316417139 (0803) Welcome & Congratulations Congratulations on your purchase of a new range! [. . . ] or to increase or decrease the set temperature. 8 Setting Oven Controls Note: The time of day must first be set in order to operate the oven. To Broil 1. Slide broiler drawer out to the stop position. Remove broiler pan & insert (See Fig. Position rack before setting control; while range is cool. Position rack by tilting front of rack up & pulling rack out from locating holes in rear of broiler drawer. Reposition back of rack in the desired locating holes & allow front of rack to slide down into the corresponding slots in front of broiler drawer (See Fig. NOTE: For mediumrare meats, position the rack closer to the burner (upper position). For well-done foods such as chicken, lobster tails or thick cuts of meat, position the rack further from the burner (lower position). Fig. Place insert on broiler pan, then place meat on insert. DO NOT use the broiler pan without the insert. DO NOT cover the insert with aluminum foil. Press & hold the key pad and release after the display begins flashing the factory temperature setting of 00 00. Note: If the oven temperature has been previously adjusted from the factory setting, the current temperature adjusted value will flash in the display instead. You may increase the oven temperature in 5°F increments with each press of the key pad to a maximum oven adjustment key pad ( total of +35°F. You may also adjust the oven temperature downward in 5°F increments with each press of the adjustment range of -35 to +35 F. Note: Your oven control was factory set in the (Fahrenheit) °F Temperature Display Mode. 35 35 To change for (Celsius) °C, see Changing the Temperature Display Mode in the Oven Control Functions section of this Use & Care Manual. If no other key pad is pressed after 5 seconds the display will begin to flash. If you do not want to keep the display adjustment, press the key pad before the oven control beeps. This will cancel the temperature adjustment procedure. To start this procedure over again begin with step 1 above OR; 5. If you want to keep the adjustment, wait until the display quits flashing and the oven control beeps once. The oven temperature adjustment has be accepted by the oven control and the display will return to the time of day. [. . . ] Products with original serial numbers that have been removed, altered or cannot be readily determined. Product that has been transferred from its original owner to another party or removed outside the USA or Canada. Rust on the interior or exterior of the unit. Products purchased "as-is" are not covered by this warranty. [. . . ]