User manual WHIRLPOOL WFE510S0AW INSTALLATION GUIDE

[. . . ] 9-11 Setting Surface Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-16 Oven Control Functions (1000G) . . . . . . . . . . . . . . . . . . . . . . . . 17 Setting Oven Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18-28 Keep Warm Drawer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The minute timer does not start or stop the cooking process. It serves as an extra timer in the kitchen that will beep when the set time has run out. The minute timer can be used alone or while using other oven features. The minute timer cannot be used with selfclean feature or when the oven door is locked. When the minute timer is in use during a cooking process, the minute timer will be shown in the display. To view the status of other features, press the pad once for the other feature to view the status of that feature. Setting lockout The control may be programmed to lock the oven door, lockout the cooktop and oven control pads. To set the lockout feature: Step Press and hold lock pad for 3 seconds. "door Loc" will appear in the display until the oven door is completely locked. To unlock the lockout feature: Step Press and hold lock pad for 3 seconds. Once the oven door has unlocked the "door Loc" message will no longer display (See Fig. Press Press NOTES DO NOT attempt to open the oven door while the "door Loc" (door lock) message is visible. After the bake time feature has been activated, press the bake time pad to display the bake time remaining. The bake time feature may be set with the convect bake and convect roast features. Bake time will not operate with the broil feature. The convection fan will begin rotating once the bake or bake time features are started. The convection fan will turn off once the set oven temperature is reached. NOTES The oven will bake no longer than 6 hours from the last time the oven door was opened. If you wish to continuously bake, see "Changing between continuous bake setting or 6-Hour Energy Saving feature" for further information. 20 SETTING OVEN CONTROLS To program oven for delayed bake time and to shut-off automatically The delay start feature allows you to set a starting and ending time to the baking process. Prior to setting a delay start, be sure the time of day is set correctly. If the delay start needs to be set more than 12 hours in advance (12-24 hours), the control must first be programmed for 24 hour display mode. See "Setting 12 or 24 hour display modes" section. "END" will appear in the display window and the oven will shut-off automatically (See Fig. The control will beep 3 times every 30 seconds as a reminder until the cancel key pad is pressed. WARNING FOOD POISONING HAZARD. [. . . ] Products with original serial numbers that have been removed, altered or cannot be readily determined. Product that has been transferred from its original owner to another party or removed outside the USA or Canada. Rust on the interior or exterior of the unit. Products purchased "as-is" are not covered by this warranty. [. . . ]