User manual WHIRLPOOL WFE710H0AS DIMENSION GUIDE

[. . . ] All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. € These words mean: DANGER WARNING You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. [. . . ] If the rear of the range lifts more than ½" (1. 3 cm) off the floor without resistance, stop tilting the range and lower it gently back to the floor. The range foot is not engaged in the anti-tip bracket. IMPORTANT: If there is a snapping or popping sound when lifting the range, the range may not be fully engaged in the bracket. Check to see if there are obstructions keeping the range from sliding to the wall or keeping the range foot from sliding into the bracket. Verify that the bracket is held securely in place by the mounting screws. Slide the range forward, and verify that the anti-tip bracket is securely attached to the floor or wall. If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket. Follow the directions in Style 1 or Style 2, depending on the style of drawer supplied with the range. For Ranges without AquaLift® Technology or Steam Clean: 1. Place level on the rack and check levelness of the range, first side to side; then front to back. Check that the circuit breaker has not tripped or the household fuse has not blown. Check that the gas shutoff valves are set to the “open” position. Check that burner caps are properly positioned on burner bases. If a burner does not light at this point, turn the control knobs to “Off” and contact your dealer or authorized service company for assistance. adjust Flame Height Adjust the height of top burner flames. The cooktop “low” burner flame should be a steady blue flame approximately ¼" (0. You can check the burner flame by using a mirror. insert a mirror to one side of the burner. The oven bake burner should light within 8 seconds. Under certain conditions, it may take the burner up to 50 to 60 seconds to light. Electronic igniters are used to light the bake and broil burners. [. . . ] Install the Natural gas bake burner orifice spud, turning it clockwise until snug. NOTE: Refer to the Model Number and Serial Number Plate located on the oven frame behind the top right side of the oven door for proper sizing of spuds for each burner location. Place LP gas orifice spuds in plastic parts bag for future use and keep with package containing literature. Replace the burner base using both screws. [. . . ]