User manual WHIRLPOOL WFG520S0AS DIMENSION GUIDE

[. . . ] All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING. You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. [. . . ] Use a ¼" drive ratchet to lower the rear leveling legs one-half turn. Use a wrench or pliers to lower front leveling legs one-half turn. 6 m), ratings are reduced at a rate of 4% for each 1, 000 ft (304. 8 m) above sea level (not applicable for Canada). On Ranges Equipped with Warming Drawers: On ranges equipped with a warming drawer, the rear legs cannot be accessed by removing the warming drawer. It will be necessary to adjust the rear legs from outside the range. Use wrench or pliers to lower the front and rear leveling legs one-half turn. Gas supply pressure for testing regulator must be at least 1" water column pressure above the manifold pressure shown on the model/serial rating plate. Line pressure testing above ½ psi gauge (14" WCP) The range and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of ½ psi (3. Line pressure testing at ½ psi gauge (14" WCP) or lower The range must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than ½ psi (3. Tip Over Hazard A child or adult can tip the range and be killed. Burner caps should be level when properly positioned. If burner caps are not properly positioned, surface burners will not light. Apply pipe-joint compound made for use with LP gas to the smaller thread ends of the flexible connector adapters (see B and G in following illustration). Attach one adapter to the gas pressure regulator and the other adapter to the gas shutoff valve. Use a ¹/" combination wrench and channel lock pliers to attach the flexible connector to the adapters. H G F Failure to follow these instructions can result in death, fire, or electrical shock. On models with a warming drawer, the rear leg cannot be seen by removing the warming drawer. It will be necessary to view the rear foot from outside the range. To check that the anti-tip bracket is installed, use a flashlight and look underneath the bottom of the range. Slide range back so rear range foot is under anti-tip bracket. The cooktop "low" burner flame should be a steady blue flame approximately ¼" (0. [. . . ] Gas pressure regulator cap with hollow end facing out C. Gas pressure regulator cap with solid end facing out D. Turn over the gas pressure regulator cap and reinstall on regulator so that the solid end faces out and the marking "<- N" is facing the direction shown in the above drawing. Replace plastic cover over gas pressure regulator cap. [. . . ]