User manual WHIRLPOOL WFG540H0AB USE & CARE GUIDE

[. . . ] Poor ventilation can produce a lack of oxygen. WARNING: The use of a gas cooking appliance produces heat and humidity in the room in which it is installed. Ensure good ventilation of the room keeping natural ventilation openings clear or installing an extractor hood with a discharge tube. In case of doubt ask installer for advice. [. . . ] Accordingly , the top of the flame should lick the bottom of the pan. In contrast with electric grids, gas burners do not require flat-bottomed pans: the flames lick the bottom and spread the heat all over the surface. No special pans are required for gas burners. A roast, especially if of red meat, must not be salted at the beginning of cooking as salt causes juices and blood to seep out of the òmeat, thus preventing the formation of a well-browned crust. It is advisable to salt the outside of the meat after just over half the cooking time. Place the roast in the oven in a dish having a low rim; a deep dish shields heat. Meat can be placed on an ovenproof dish or directly on the grill, under which the dripping pan will be inserted to collect juice. Ingredients for gravy should only be put in the dish immediately if cooking time is brief, otherwise they should be added during the last half hour. Begin cooking rare meat at a high temperature, reducing the temperature to finish cooking the inside. The cooking temperature for white meat can be moderate throughout. The degree of cooking can be checked by pressing the meat with a fork; if it does not give the meat is cooked. Do not use steel wool or knives to take off layers of crust. Remove stubborn marks with a well wetted soap impregnated pad, but care must be taken not to scratch the enamel. Wash the enamelled grids with water and detergent; these can also be washed a dishwasher. Take off the burner covers and the grids and wash them carefully with warm water and detergent. Dry them well before putting them back in position. Moreover, make sure that these are properly re-placed. The burner can be rubbed with steel wool or a slightly abrasive cloth. Clean the oven door and crystal cover, in models equipped with these items, only with warm water, and avoid the use of rough cloths or abrasive substances; in cookers with an automatic ignition the sparkling bulb should be cleaned periodically and accurately to avoid difficulties in lighting; furthermore check that the burner holes are not obstructed. Fig. 12 FO 0424 Cleaning the oven Clean carefully the oven cavity after use when it is still warm. In fact, at this moment it is easy to take off deposits of fat or other substances such as fruit juice, sugar particles or fat. You can use warm detergent water or one of the appropriate spray oven cleaners. [. . . ] 18) the nozzles replacing them with the ones required for the kind of gas in use (see Technical data). Reassemble the parts following the same procedure backwards. These burners do not need any primary air regulation. Fig. Adjustment of minimum level To adjust the minimum level: 1) turn the knob to the position of minimum flame; 2) remove the knob (Fig. [. . . ]