User manual WHIRLPOOL WFG720H0AS INSTALLATION GUIDE

[. . . ] W10553363A RANGE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] Style 1: Ranges Equipped with a Storage Drawer: Use a ¼" drive ratchet, wrench or pliers to adjust leveling legs up or down until the range is level. Check that rear leveling leg is engaged in the anti-tip bracket. Style 2: Ranges Equipped with a Warming Drawer or Premium Storage Drawer: Use a wrench or pliers to adjust leveling legs up or down until the range is level. Check that rear leveling leg is engaged in the anti-tip bracket. NOTE: Range must be level for satisfactory baking performance and best cleaning results using AquaLift® Technology and Steam Clean functions. 10 Electronic Ignition System Initial lighting and gas flame adjustments Cooktop and oven burners use electronic igniters in place of standing pilots. When the cooktop control knob is turned to the “LITE” position, the system creates a spark to light the burner. This sparking continues, as long as the control knob is turned to “LITE. € When the oven control is turned to the desired setting, sparking occurs and ignites the gas. Light 1 burner and turn to lowest setting. Hold the knob stem with a pair of pliers. Use a small flatblade screwdriver to turn the screw located in the center of the control knob stem until the flame is the proper size. Test the flame by turning the control from “LO” to “HI, ” checking the flame at each setting. Check Operation of Cooktop Burners Standard Surface Burners Push in and turn each control knob to the “LITE” position. The flame should light within 4 seconds. The first time a burner is lit, it may take longer than 4 seconds to light because of air in the gas line. To remove the oven bottom: Remove 2 screws at the rear of the oven bottom. Lift the rear of the oven bottom up and back until the front of the panel is away from the front frame. Remove from oven and place on a covered surface. If burners do not light properly: ■ ■ ■ ■ Turn cooktop control knob to the “OFF” position. Check that the circuit breaker has not tripped or the household fuse has not blown. Check that the gas shutoff valves are set to the “open” position. [. . . ] Repeat steps 1-7 for the remaining burners. Position the back of the bake burner over the oven orifice, and slide the tab on front of the bake burner into the front of the oven. Position the front of the oven bottom panel toward the front frame and lower the rear of the oven bottom panel into the oven. Reattach the oven bottom panel with 2 screws. [. . . ]