User manual WHIRLPOOL WFW94HEAC INSTALLATION GUIDE

[. . . ] 2 m) of hot and cold water fill valves on washer, and water pressure of 20-100 psi (137. N A level floor with maximum slope of 1" (25 mm) under entire washer. Installing on carpet or surfaces with foam backing is not recommended. N Floor must support washer’s total weight (with water and load) of 315 lbs (143 kgs). [. . . ] Slide each bolt and spacer to center of hole. Pull bolts and plastic spacers from back of washer. Cover bolt holes with transport  bolt hole plugs Remove the yellow shipping strap from the cord. Gently place power cord over top of washer to allow free access to back of washer. IMPORTANT: Do not plug washer in until installation has been completed. Attach drain hose to drain port Ribs Close bolt holes on cabinet back with four transport bolt hole plugs included with washer parts. Remove power cord If clamp is not already in place on elbow end of drain hose, squeeze clamp with pliers and slide it over end of hose, centering it between the ribs, as shown. Squeeze clamp with pliers and slide elbow end of drain hose onto drain port and secure with clamp. For a laundry tub or standpipe drain, go to step 9. For a floor drain, remove the preinstalled drain hose form as shown in Step 8. You may need additional parts with separate directions. Pull power cord through opening in rear panel and close hole with attached cap. NOTE: If washer is transported at later date, call your local service center to avoid suspension and structural damage, a certified technician must properly set up washer for relocation. Washer IMPORTANT: To avoid leaks, check that your water inlet hoses have flat washers at both ends. Washer must be connected to water faucets with new inlet hoses with flat washers (not provided). For floor drain installations, you will need to remove the drain hose form from the end of the drain hose. You may need additional parts with separate directions. 5" (114 mm) of drain hose should be inside standpipe; do not force excess hose into standpipe or lay on bottom of laundry tub. Screw on coupling by hand until it is seated on washer. use pliers to tighten couplings an additional two-thirds turn. Repeat this step with the hose labeled cold for the cold water faucet. Both hoses must be connected for washer to work properly. [. . . ] Q Check that all parts are now installed. If there is an extra part, q Check that you have all of your tools. Q Check that transport materials were completely removed from back of washer. Q Check that both hot and cold hoses are attached and water q Check for leaks around faucets, valves, and inlet hoses. [. . . ]