User manual WHIRLPOOL WGD49STBW DIMENSION GUIDE

[. . . ] Gas Dryer PRODUCT MODEL NUMBERS WGD49STB 29" Wide Models Dryer Dimensions Front View Side View 29" (737 mm) 223/4" (578 mm) 273/4" (705 mm) 133/4" (349 mm) 273/4" (705 mm) 433/8" (1102 mm) 1/2" (13 mm) A A. Wide opening hamper door Back View B NOTE: Leveling legs should be 1/2" (13 mm) (to match height of 3. 6 cu. [. . . ] ■■ Additional clearances might be required for wall, door, and floor moldings. ■■ Additional spacing of 1" (25 mm) on all sides of the dryer is recommended to reduce noise transfer. ■■ For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable. ■■ Companion appliance spacing should also be considered. INSTALLATION REQUIREMENTS GAS SUPPLY REQUIREMENTS Gas supply: This dryer is equipped for use with Natural gas. When rigid pipe is used it should be 1/2" IPS. When acceptable to the gas supplier and local codes, 3/8" approved tubing may be used for lengths under 20 ft (6. 1 m). For lengths over 20 ft (6. 1 m), larger tubing should be used. Pipe-joint compounds resistant to the action of L. P. An individual manual shutoff valve must be installed within 6 ft (1. 8 m) of the dryer in accordance with the National Fuel Gas Code ANSI Z223. 1. ELECTRICAL REQUIREMENTS A 120-volt, 60 Hz, AC-only, 15 or 20 amp fused electrical supply is required. A time-delay fuse or circuit breaker and a separate circuit are recommended. WATER (STEAM MODELS ONLY) REQUIREMENTS The dryer must be connected to the cold water faucet using new inlet hoses. Damage to the coupling can result. VENTING REQUIREMENTS Exhaust venting: Exhaust your dryer to the outside. [. . . ] For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. [. . . ]