User manual WHIRLPOOL WGD9750WW INSTALLATION

[. . . ] Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] No attempt shall be made to convert the appliance from the gas specified on the model/serial rating plate for use with a different gas without consulting your gas company. Use an elbow and a 3/8" flare x 3/8" NPT adapter fitting between the flexible gas connector and the dryer gas pipe, as needed to avoid kinking. This dryer must be connected to the gas supply line with a listed flexible gas connector that complies with the standard for connectors for gas appliances, ANSI Z21. Elevations above 10, 000 ft (3, 048 m): When installed above 10, 000 ft (3, 048 m) a 4% reduction of the burner Btu rating shown on the model/serial number plate is required for each 1, 000 ft (305 m) increase in elevation. Gas supply pressure testing Gas supply line The dryer must be disconnected from the gas supply piping system during pressure testing at pressures greater than ½ psi. Must include 1/8" NPT minimum plugged tapping accessible for test gauge connection, immediately upstream of the gas connection to the dryer. If you are using Natural gas, do not use copper tubing. 1 m) should use larger tubing and a different size adapter fitting. The gas pipe that comes out through the rear of your dryer has a 3/8" male pipe thread. 5" (394 mm) from the floor, depending on the pedestal model. For a garage installation, the gas pipe height must be an additional 18" (457 mm) from the floor. If flexible metal tubing is used, be sure there are no kinks. Failure to follow these instructions can result in death, fire, or electrical shock. NOTE: For LP gas connections, you must use pipe-joint compound resistant to the action of LP gas. A combination of pipe fittings must be used to connect the dryer to the existing gas line. Your connection may be different, according to the supply line type, size and location. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. This dryer is equipped with a cord having an equipmentgrounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. Grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative or personnel if you are in doubt as to whether the dryer is properly grounded. Do not modify the plug provided with the dryer: if it will not fit the outlet, have a proper outlet installed by a qualified electrician. [. . . ] Press any key to clear the code from the display and return to the estimated time remaining. Check that both fuses are intact and tight, or that both circuit breakers have not tripped. replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. [. . . ]