User manual WHIRLPOOL WGG755S0BE DIMENSION GUIDE

[. . . ] All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. € These words mean: DANGER WARNING You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. [. . . ] Using 2 or more people, firmly grasp the range and gently lay it on its back on the cardboard corners. Use an adjustable wrench to loosen the leveling legs. Using 2 or more people, stand range back up onto cardboard or hardboard. iMPORTANT: All connections must be wrench-tightened. Do not make connections to the gas pressure regulator too tight. Making the connections too tight may crack the regulator and cause a gas leak. Do not allow the regulator to turn when tightening the fittings. Burner caps should be level when properly positioned. If burner caps are not properly positioned, surface burners will not light. Failure to follow these instructions can result in death, fire, or electrical shock. Gas supply pipe must be located within the shaded area as shown in the “Cabinet Dimensions” illustration in “Location Requirements” section. 3 cm) off the floor without resistance, the anti-tip bracket may not be installed correctly. Do not operate the range without anti-tip bracket installed and engaged. Please reference the “Assistance or Service” section of the Use and Care Guide, or the cover or “Warranty” section of the User Instructions, to contact service. Check Operation of Cooktop Burners Standard Surface Burners Push in and turn each control knob to the “IGNITE” position. The flame should light within 4 seconds. The first time a burner is lit, it may take longer than 4 seconds to light because of air in the gas line. If burners do not light properly: ■ ■ Turn cooktop control knob to the “OFF” position. Check that the range is plugged in and the circuit breaker has not tripped or the household fuse has not blown. Check that the gas shutoff valve is set to the “open” position. Check that burner caps are properly positioned on burner bases. If a burner does not light at this point, turn the control knobs to “OFF” and contact your dealer or authorized service company for assistance. [. . . ] Screw the regulator cap securely back into place. Unscrew and remove the cover over the orifice. Position the oven bake burner over the orifice hood and reinstall using screw. Repeat previous steps 1 through 8 for conversion of the upper oven bake burner. [. . . ]