User manual WHIRLPOOL WGT3300SQ

[. . . ] If you need assistance or service, first see the "Troubleshooting" section. Additional help is available by calling our Customer eXperience Center at 1-800-253-1301 from anywhere in the U. , or write: Whirlpool Corporation Customer eXperience Center 553 Benson Road Benton Harbor, MI 49022-2692 Information may also be obtained by visiting our website at www. In Canada, for assistance, installation or service, call us at 1-800-807-6777, or write: Whirlpool Canada LP Customer Interaction Centre 1901 Minnesota Court Mississauga, Ontario L5N 3A7 In Canada, visit www. [. . . ] Replace water inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace water inlet hoses if bulges, kinks, cuts, wear, or leaks are found. When replacing your water inlet hoses, mark the date of replacement on the label with a permanent marker. First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call. Washer won't run, fill, rinse, or agitate; washer stops Is the floor flexing, sagging, or not level?Flooring that flexes or is uneven can contribute to noise and vibration of the washer. Evenly distribute the load in the washer basket and make sure the height of the load does not exceed the top row of basket holes. Did you completely remove the yellow shipping strap with cotter pins?Are the gears engaging after the drain and before spin, or is the upper part of agitator clicking during wash?When the washer drains, the pump will make a continuous humming with periodic gurgling or surging sounds as the final amounts of water are removed. Failure to follow these instructions can result in death, fire, or electrical shock. Is the power cord plugged into a grounded 3 prong outlet?Plug power cord into a grounded 3 prong outlet. Turn the Cycle Control knob to the right slightly and pull to start. are the water inlet valve screens clogged?Turn off the water and remove inlet hoses from the washer. Are both the hot and cold water faucets turned on?Does the water level seem too low, or does the washer appear to not fill completely?The top of the agitator is much higher than the highest water level. This is normal and necessary for clothes to move freely. If the problem continues, call an electrician. is the washer in a normal pause in the cycle? [. . . ] iTEMS EXCLUDED FROM WARRANTY This limited warranty does not cover: 1. Replacement parts or repair labor if this major appliance is used for other than normal, single-family household use or when it is used in a manner that is inconsistent to published user or operator instructions and/or installation instructions. Service calls to correct the installation of your major appliance, to instruct you on how to use your major appliance, to replace or repair house fuses, or to correct house wiring or plumbing. Service calls to repair or replace appliance light bulbs, air filters or water filters. [. . . ]