User manual WHIRLPOOL WHM1411 INSTRUCTION FOR USE

[. . . ] INSTRUCTIONS FOR USE • Has the packaging been removed from under the appliance?Note: gurgling noises from the refrigerating circuit after the compressor cuts out are perfectly normal. The green LED (if provided) is off and the appliance is not working. • Is the plug properly inserted in the socket? [. . . ] The exact configuration of the controls may vary according to the model. Switching on the appliance • The appliance is factory set for optimum operation at a temperature of -18°C. • The green LED lights up (if provided). • Also the red LED (if provided) will switch on because the temperature inside the appliance is not yet sufficiently low for food storage. The red LED will normally switch off within the first six hours after the appliance is switched on. • After connecting the appliance to the mains supply and when the optimal temperature has been reached (this phase takes about 1 hour during which the lid will not open), ensure that the fast freeze button is not pressed (the yellow LED, if provided, is off). • Place food inside the product only when the red LED (if provided) has switched off. • Thanks to the efficient lid seal, the appliance lid will not reopen easily immediately after closing. Wait a few minutes before re-opening the lid of the appliance. Temperature Adjustment Use the thermostat to select the ideal storage temperature. To adjust the internal temperature, proceed as follows: • Turn the thermostat knob to 1 for a storage temperature that is less cold. • Turn the thermostat knob to 6 / for a colder storage temperature. • For partial loads, or when the load indicator is below the "e" symbol inside the appliance (if present), it is advisable to move the thermostat to the lower position (on "e", if present on the thermostat scale). cod. 5019 613 01095/B CO Small INSTRUCTIONS FOR USE BEFORE USING THE APPLIANCE Your new appliance is designed exclusively for domestic use and for storing frozen food, freezing fresh food and making ice cubes. Regulations require that the appliance is earthed. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the above procedures and reminders. After unpacking, make sure that the appliance is undamaged and that the lid closes perfectly tight. Any damage must be reported to your dealer within 24 hours after delivery of the appliance. Wait at least two hours before switching the appliance on in order to ensure the refrigerant circuit is fully efficient. Installation of the appliance and electrical connections must be carried out by a qualified electrician, in accordance with the manufacturer's instructions and local safety regulations. Clean the inside of the appliance before using it. • Before connecting the appliance to the mains supply, ensure that the voltage corresponds to that given on the rating plate located on the rear of the appliance. [. . . ] • In order to avoid permanent damage to the appliance interior, do not use pointed or sharp metal instruments for removing the ice. • Do not use abrasive products or heat up the interior artificially. • Dry the interior of the appliance thoroughly. • On completion of the defrosting, refit the plug. [. . . ]