User manual WHIRLPOOL WMA1887DFC TS AQUA PRODUCT FICHE

[. . . ] Fitting and replacing the active carbon filter The water filter should be removed from the foil bag (found in the crisper drawer. Follow the instructions provided with the filter. Important: If the filter is left dry for an extended period of time, its performance may be reduced. [. . . ] Immerse the filter in water for a few seconds to reinstate optimum performance. 1) The water tank is made of antibacterial material. This prevents and reduces the proliferation of bacteria. An internal container, with an active carbon filtered ensures water filtration. To fill the tank: rotate the water inlet towards you and fill with water, using a jug or other suitable container. Once the tank is full, close the water inlet by moving it back to its original position. Always use drinking water only: any other liquid may impair product performance. To fill the tank, rotate the cap in the direction of the arrow Tank Fig. 5a -5b) remove the internal container and the filter, and wash them separately. When washing the filter, only use clean water (no detergent or sharp tools). To clean the disk filter, first remove it from the container. Fig. 6) for a more thorough cleaning, remove the valve cap (the fitting connecting the tank to the refrigerator) by rotating it anticlockwise. Important: do not pull on the valve body (fig. 8) replace the valve cap by rotating clockwise. Fig. 9) fit the tank back in place by placing it between the lateral guides of the door and pushing it in position, ensuring that the valve is back in its original seat. [. . . ] 8) replace the valve cap by rotating clockwise. Fig. 9) fit the tank back in place by placing it between the lateral guides of the door and pushing it in position, ensuring that the valve is back in its original seat. Check that the there are no gaps between the rubber seal of the tank and the door. [. . . ]