User manual WHIRLPOOL WMC10007AW INSTALLATION GUIDE

[. . . ] You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. W10482078A/JS1M0609-18261-005 INSTALLATION REQUIREMENTS Tools and Parts Tools Needed Gather the required tools and parts before starting installation. [. . . ] WARNING: Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the microwave oven is properly grounded. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven. SAVE THESE INSTRUCTIONS INSTALLATION INSTRUCTIONS Place Cabinet Template The shadowed area of Template A represents the top of the microwave oven. Make sure it is centered in the space where the microwave oven will be installed. installation Under Cabinet with Partition 1. If the cabinet has a partition, or if the microwave oven is being installed under adjoining cabinets, cut Template B from Template A. Cut Template A into two pieces to fit into each side of the partition. Align each piece of Template A so that it is flush with the front edge of the cabinet, as shown. Cabinet front edge B Installation Under Cabinet without Partition 1. If the cabinet does not have a partition, place the template (Template A) on the lower shelf of the cabinet, as shown in the illustration at the beginning of this section. Align the Hole Centerlines of Template A with those of Template B, as shown. Mark the four hole centers through the template onto the lower shelf of the cabinet. Following are the dimensions for the mounting holes on Template A: 4 ⁵⁄₁₆" (10. 9 cm) Install the Microwave Oven 1. Remove the plugs from the four mounting holes on the top of the microwave oven. [. . . ] If the problem continues, call an electrician. Slide the slotted portion of each C-washer against each bolt. These washers will temporarily hold the microwave oven while installation is being completed. [. . . ]