User manual WHIRLPOOL WMT 50 IK PRODUCT FICHE

[. . . ] After unpacking the appliance, make sure it is not damaged and that the door closes properly. Any functional fault must be reported to IKEA After Sales Service as soon as possible. Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient. The electrical installation and the electrical connection must be carried out by a qualified technician according to the manufacturer’s instructions and in compliance with the local safety regulations. [. . . ] Following table shows set-points level: High temperature Mid-high temperature (Eco green) Middle temperature Mid-low temperature Low temperature Legend: Led OFF Led ON Fast Cooling The use of this function is recommended when placing a very high quantity of food in the refrigerator compartment. By pressing and hold the pushbutton on the control panel for 3 sec. It is possible to increase the cooling speed of the foods inside the refrigerator compartment. Fast Cooling ON Fast Cooling OFF The Fast Cooling light (yellow LED) will turn on. The function is automatically deactivated after 6 hours. The Fast Cooling function can be manually deactivated by pressing and hold the same pushbutton on the control panel for 3 sec. ENGLISH 8 Note: - Fast Cooling function should be also switched ON before placing fresh food to be frozen in the freezer compartment. - Fast Cooling function has to be engaged in order to maximize freezing capacity, thus it has to be engaged before to add fresh food. Freezing fresh food Place the fresh food to be frozen inside bottom basket in the freezer compartment. avoid direct contact with already frozen food. To freeze the quantity of food shown on the rating plate. ENGLISH 9 Cleaning and maintenance Regularly clean the appliance using a cloth and a solution of warm water, with some soft detergent suitable for cleaning the inside of the refrigerator compartment. do not use abrasive detergents or tools. To ensure continuous and correct flow of defrost water, regularly clean the inside of the draining hole on the back of the refrigerator near the fruit and vegetable drawer, using the tool provided (see fig. Before carrying out any cleaning or maintenance operation, unplug the appliance or disconnect it from the power supply. Use up perishable food, freeze other food. If your appliance has an automatic ice maker: 1. Shut off the water supply to the automatic ice maker. Wrap them well, and fix them together with adhesive tape so that they do not bang together or get lost. Screw the adjustable feet so that they do not touch the support surface. Close and fix both doors with adhesive tape and, again using adhesive tape, fix the power cable to the appliance. If the appliance is not going to be used Disconnect the appliance from the power supply, remove all the food, defrost and clean. [. . . ] Note: Some of functional noises coming from appliance during normal use can be within hearing: - A hissing sound when switching on the appliance for the first time or after a long pause. - A gurgling sound when refrigerant fluid enters into the pipes. - Buzzing sound when water valve or fan start working. - A cracking sound when compressor starts or when ready ice drops into ice box Abrupt clicks when compressor switches on and off. [. . . ]