User manual WHIRLPOOL WMT552 W PRODUCT FICHE

[. . . ] Up to a temperature of 30°C, this programme is particularly suitable to treat delicate lingerie (use of a laundry net strongly recommended). This programme (40°C) is tested and approved by The Woolmark Company for handwashable wool. Same as the last rinse and the final spin in the “Cotton” programme. in this programme spinning is intensive. [. . . ] In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your Instructions for Use; if the fault persists, contact our After Sales Service. “Water tap closed” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in your Instructions for Use. “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The time indicated on the display can deviate from the values in the table, because it takes into account the household * conditions applicable at that time. To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. Increases the cycle time by approximately 15 min. € Do not use liquid detergent for the main wash when activating the Prewash option. €Rinse hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. • This option is particularly recommended for the programmes “Synthetics” , “Daily load” and “Delicates”. € It is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. € If you select “Rinse hold”, do not leave the laundry to soak for too long. Note: The programme stops to “Rinse hold” at the time the “Rinse hold” light in the programme sequence indicator is on. The indication lamp next to the “Start” button blinks. Terminate the “Rinse hold” option: • Press the “Start” button; the programme will terminate automatically with the final spin cycle for the present wash programme. € If you do not wish to spin the clothes, turn the programme selector to the “Drain” programme and press the “Start” button. “Intensive rinse” button • More water is added and rinse cycle is prolonged. [. . . ] press the “Start” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. PROGRAMME START Open the tap and press the “Start” button. [. . . ]