User manual WHIRLPOOL WOD51ES4ES INSTALLATION GUIDE

[. . . ] E D C  For undercounter installation, it is recommended NOTE: that the junction box be located in the adjacent right or left cabinet. If you are installing the junction box on rear wall behind oven, the junction box must be recessed and located in the upper or lower right or left corner of the cabinet; otherwise, the oven will not fit into the cabinet opening. Cutout height  ven support surface must be solid, level, and flush with O bottom of cabinet cutout. Floor must be able to support a single oven weight of 140 lbs (63. [. . . ] The length of conduit provided D is for serviceability of the oven.  ocate the oven door latches in both corners of the oven L door, and rotate the latches forward to the unlocked position. Grasp the edges of the oven door with both hands and close the oven door until it will no longer close. Lift and pull oven door toward you and remove. Set the oven door aside on a covered work surface. Electrical Connection Options Chart If your home has: 4-wire Go to section: 4-Wire Cable from Home Power Supply ½" (1. 3 cm) 3-wire 3-Wire Cable from Home Power Supply Make Electrical Connection ½" (1. 3 cm) 4-Wire Cable from Home Power Supply IMPORTANT: Use the 4-wire cable from home power supply in the U. Where local codes do not allow grounding through neutral, New Branch circuit installations (1996 NEC), mobile homes and recreational vehicles, new construction and in Canada. Failure to follow these instructions can result in death, fire, or electrical shock. The oven is manufactured with a neutral (white) power supply wire and a cabinet-connected green (or bare) ground wire twisted together.  eed the flexible conduit from the oven through the opening F in the cabinet.  oute the flexible conduit from the oven to the junction box R through a UL-listed or CSA-approved conduit connector.  ee “Electrical Connection Options Chart” to complete S installation for your type of electrical connection.  onnect the 2 black wires (B) together using a UL-listed wire C connector.  onnect the 2 red wires (C) together using a UL-listed wire C connector.  ntwist white wire from green (or bare) ground wire coming U from the oven.  onnect the 2 white wires (F) together using a UL-listed wire C connector.  onnect the green (or bare) ground wire (H) from the oven C cable to the green (or bare) ground wire (in the junction box) using a UL-listed wire connector. Only IMPORTANT: Use the 3-wire cable from home power supply where local codes permit a 3-wire connection.  Push against seal area of front frame to push oven into cabinet.  ush oven completely into cabinet and center oven P into cabinet cutout. [. . . ] If it is not, repeat C the removal and installation procedures.  isplay panel will light briefly, and “PF” should appear D in the display. f display panel does not light, please reference the I “Assistance or Service” section of the Use and Care Guide or contact the dealer from whom you purchased your oven.  heck that all parts are now installed. [. . . ]