User manual WHIRLPOOL WOS97ES0ES INSTALLATION GUIDE

[. . . ] W10777368B BUILT-IN OVEN SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] If the door hinge lock is not rotated fully (see illustration B), the door will not remove properly.  the oven door(s) aside on the prepared covered work Set surface, with the oven door resting on its handle.  continue with the oven installation, go to the “Positioning To Oven Feet for Multiple Cabinet Cutout Heights” section.  sing two hands, grasp side edges of door at the midpoint.  ocate the slots on each side of the oven cavity for the door L hinge locks.  ven door hinge lock O in locked position B.  ven door hinge lock O in unlocked position A A. Slot in the oven cavity for door hinge lock 7 3.  a 45° angle, align door hinges with slots in the lower At front of the oven cavity. Slowly insert door, making sure you maintain the 45° angle. You will know the door is engaged in the slot when you feel a slight drop. Positioning Oven Feet for Multiple Cabinet Cutout Heights Single Ovens The positioning of the oven feet allow a single oven to be installed in a cutout height between 2615⁄16" and 297⁄16" (68. Refer to the following instructions to position the feet for the size of your cabinet cutout. 7 cm) The oven feet do not need to be changed.  Lower the oven door to the fully open position. If the oven door does not open to a full 90°, repeat steps 1 through 3.  Locate the oven door hinge locks in the corners of the oven door, and rotate the hinge locks toward the oven cavity to the locked position.  See Step 3 (illustration A) in the “Remove Oven Door(s)” section for proper locked position.  When the hinges are properly installed and the door closed, there should be an even gap between the door and the control panel. If one side of the oven door is hanging lower than the other, the hinge on that side is not properly installed. Using 2 or more people, place the oven on its back on a covered surface. Using 2 or more people, place the oven on its back on a covered surface. [. . . ] The display panel will light briefly, and “PF” should appear  in the display. If the display panel does not light, please reference the  “Warranty” section of the Use and Care Guide. –  nstall the bottom vent trim (B) to the lower vent piece (D) I Install Warming Drawer Deflector Kit (Only for Ovens Installed Above Warming Drawers) On single and double oven models installed above a warming drawer, a warming drawer deflector kit must be installed. See the “Tools and Parts” section for information on ordering. [. . . ]