User manual WHIRLPOOL WRB551WNBS PRODUCT FICHE

[. . . ] Move the screws to the center of the holes and Pull out the screws together with the black remove them. Or: First remove all 4 screws, and then remove the black rubber parts by means of a screwdriver or similar. Make sure that the red plastic parts do not remain stuck in the holes if so, push them with a screwdriver so that they fall down towards the inside of the washer. [. . . ] Tilt the washer slightly to the front, so that a 2nd person can pick up the red plastic parts. Put the black rubber and the red plastic parts back on the removed screws again and keep the transport bolts for any further transporting of the washer. To close the holes, insert the supplied plastic caps in the wide part of the holes and slide them into the direction of the arrow until they click into place. Sulje reiät työntämällä niihin muovitulpat (jotka ovat laitteen takana tai toimitetussa pussissa) To close the holes, push the plastic caps (which are either attached on the back of the appliance or contained in the bag supplied) on the holes. The appliance must be installed on a solid and level floor surface (if necessary use a spirit level). If the appliance is to be installed on a wooden or floating floor, distribute the weight by placing it on a sheet of plywood measuring at least 60 x 60 cm and thickness of at least 3 cm which is secured to the floor. If the floor is uneven, adjust the 4 levelling feet as required; do not insert pieces of wood etc. Slacken the locknut clockwise (see arrow) using the wrench C supplied. Lift slightly the machine and adjust the height of the foot revolving it. In case the drain hose is installed in the upper part of the washing machine: Unclip it from both holders marked by the arrows (see below, depending on the model). If your washing machine is a built-in model: Connect the drain hose to the siphon. Notes: • Make sure there are no kinks in the drain hose. € Height for siphon - drain hose connection must be minimum 70 cm and maximum 125 cm • To make an extension, use a hose of the same type and secure the connections with clips. € Maximum overall drain hose length: 2, 50 m (in this case, the maximum height for fixation to siphon is 90 cm). If your washing machine is NOT a built-in model: Connect the drain hose to the siphon or hook it over the edge of a sink by means of the “U” bend. Fit the “U” bend E, if not already installed, at the very end of the drain hose. Important: Do not fix the “U” bend to another position of the drain hose, otherwise there might be the risk of simultaneous filling and draining of the machine (“siphoning effect”). Notes: • Make sure there are no kinks in the drain hose. [. . . ] Notes: • Make sure there are no kinks in the drain hose. € Secure the hose so that it cannot fall down. • Small hand basins are not suitable. [. . . ]