User manual WHIRLPOOL WRF535SWBW DIMENSION GUIDE

[. . . ] Installation: Water . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Door Kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 10 11 12 13 14 15 15 16 17 18 18 19 Reverse Door Swing Initial Start Up . Component Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Maintenance & Cleaning . [. . . ] Remove the three screws holding the top hinge to the cabinet. Remove that hinge from the top and, flipping it upside down, install it onto the bottom of the door, on the opposite side using the original screws. Remove the hinge assembly from the bottom of the door, and flip it upside down; secure it to the cabinet at the opposite side top position with the original screws. Secure the door to the top hinge with the original screws. Secure the bottom hinge to the cabinet with the original screws. Place the plastic plugs removed earlier into the empty holes. Check operation of the door by opening and closing it. Hinge Magnetic Gasket Reverse Hinges From Top to Bottom and Left to Right to Reverse Door Swing Door August 1995 Page 11 WRF535SWBW AFTER INSTALLATION - OPERATION Final Check List 1. Has the machine been properly uncrated, and have all packing materials and tape been removed from inside the bin?Have the installation instructions been followed, including connecting the machine to water, drain and electricity?Has the machine been leveled? How To Use: The ice machine is extremely simple to use, just turn the ice machine control knob to the on position. The WRF535SWBW will automatically begin to freeze ice and will continue to do so until the bin is full. Record the serial number and date of start up here in the manual. Keep the manual handy for future reference. Serial Number:___________________________ Date of initial start up:_____________________ 8. Fill out and mail the Warranty Registration. March 2006 Page 12 WRF535SWBW OPERATION How does the machine make ice? There are two distinct cycles: freeze and harvest. 1 freeze cycle + 1 harvest cycle = 1 batch of 8 cubes. The Freeze cycle happens when water is sprayed against the freezing surface. The Harvest cycle is when the ice is released and water enters the machine. A complete cycle takes about 30 minutes. Freeze: During the freeze cycle the compressor is pumping refrigerant, the fan motor is blowing air, and the water pump is circulating water. As the refrigerated surface absorbs heat from the water sprayed against it, that heat is moved to the area where the fan is blowing air. The heat is transferred to the air, and the warmed up air is discharged from the ice machine. [. . . ] Unplug or disconnect the electrical power to the ice machine. Pull the machine out from its installed location. Remove the screws holding the bin thermostat to the control box. Capillary Tube Cube Size Control The cube size control controls the timer during the freeze cycle. [. . . ]