User manual WHIRLPOOL WRF989SDAH ENERGY GUIDE

[. . . ] Flaked or nugget ice is not recommended for use in these dispensers. Cuber Application Chart Cuber Model CME306 CME456 CME256* CME506* CME686 or CME810 CME686 or CME810 Fits Dispenser WRF989SDAH WRF989SDAH HD30 HD30 WRF989SDAH HD30 Adapter None Needed None Needed None Needed None Needed KBT36 KBT32 Ice from the cuber falls into the insulated hopper, where it is stored until needed. When a user pushes the dispense chute a rotating wheel scoops the ice up to the top front of the hopper where there is an outlet to the ice chute. * Higher capacity cubers, CME656 or CME806, may also be used, but they require 230 volt power. New dispenser / used ice machine combinations: Some of the ice machines listed in the table above used a thermostat when on a dispenser. [. . . ] The side and front exterior panels are stainless steel. The vending area and top panel are made of plastic. Coin / Token Model The coin op model's operation is identical to the basic operation described above with the exception that no power is provided to the vend switch until the coin mechanism has activated the vend timer. The vend timer then allows the vend switch to be activated for a set time, during that time the user must dispense the ice. A green "ready" light over the vending area will glow when the vend timer is armed and ready for dispensing. Bin Sweep Arm Dispense Wheel Drain Hose to Ice Catch Pan Drain Hose September 2003 Page 6 WRF989SDAH and HD30 Unpacking After removing the carton, check for the loose-shipped parts packed in the storage bin. The parts will include a carton with four legs. Remove the leg carton and any other loose-shipped items. To remove the skid, place part of the carton behind the unit and tip the unit on its back. Remove the bolts holding the skid to the base of the HD dispenser and separate the skid from the unit. Install the legs into the base of the unit, using the holes where the skid bolts were. Turn the leg leveler part of the legs in all the way, adjust them later after the unit is in its final installed position. The drains and electrical supply must be separate. Follow All Local State and National Codes Ice Machine All models: Place the dispenser in the location where it will be used. Level the top edge of the dispenser front to back and left to right. Sanitize the dispenser bin with a locally approved sanitizer. Place the ice machine on the dispenser and secure it to the dispenser with the hardware and straps from the ice machine. Install it according to the instructions in the manual included with the ice machine. Fasten Ice Machine to Dispenser Ice Machine Drain, Keep Separate Floor Drain Back View of HD30 Installation Back View of WRF989SDAH Installation September 2003 Page 9 WRF989SDAH and HD30 Final Check List/Initial Start Up 1. Check that electrical power has been supplied. Check that a drain, separate from the ice machine, insulated and made of rigid tubing, has been connected to the dispenser. Check that the ice machine has been properly installed per the ice machines installation directions. Check that the ice machine/dispenser assembly is level front to back and left to right. The dispensing system will cycle on for a few seconds. [. . . ] A possible sanitizer: Mix a solution of ice machine sanitizer and water: 1 ounce of household bleach to 2 gallons of (95oF. -1150F. ) water. Wash all interior surfaces, the sweep arm and Hair Pin the dispense wheel with the sanitizer solution. Reassemble wheel and sweep arm onto drive shaft. Reconnect power, be sure ice machine is switched back on. Sweep Arm September 2003 Page 13 WRF989SDAH and HD30 Maintenance Spilled ice and user debris will collect in the ice catch pan, located just below the sink grill. [. . . ]