User manual WHIRLPOOL WRS322FDAD USE & CARE GUIDE

[. . . ] Improper hook-up can result in substantial property damage!If you are unsure of your ability to safely connect the water supply to the unit, consult a licensed plumber for assistance. · This unit requires connection to a grounded (threeprong), polarized receptacle that has been placed by a qualified electrician in accordance with applicable electrical codes. Safety Alert Definitions Safety items throughout this guide are labeled with a Danger, Warning or Caution based on the risk type: DANGER Danger means that failure to follow this safety statement will result in severe personal injury or death. WARNING Warning means that failure to follow this safety statement could result in serious personal injury, or death. CAUTION Caution means that failure to follow this safety statement may result in minor or moderate personal injury, property or equipment damage. www. U-LineService. com 2 02/2005 CO29A and CO29FF Ice Maker/Refrigerators General Precautions Use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide: 2 Inspect and Plan You have received a carton containing your CO29A or CO29FF Ice Maker/Refrigerator with a package inside containing a User Manual, a Product Registration Card and water connection parts. Complete and mail the Product Registration Card or register online at www. U-LineService. com. [. . . ] Remove plastic hole plug from door handle and relocate on opposite side. Fasten upper hinge to unit (three screws). Tighten upper and lower hinge screws securely. Replace three plastic plugs removed in Step 8 into holes on top of unit. Replace screws in holes in bottom of unit on opposite side. Figure 8 Figure 11 Hinge Other Site Requirements Power Supply Plastic Plug Hole Plastic Plug Hole The unit requires a grounded and polarized 115 VAC, 60 Hz, 15A circuit (normal household current). See Electrical Specifications on Page 9. Screw Right Side Door Swing Right Side Hinge Invert Screw Invert Hinge Left Side Door Swing Water Supply The unit requires a 1/4-inch OD water supply line and a shut-off valve. For more information see Page 8. Figure 9 7. Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge. Remove three plastic screw plugs from hinge holes, top of cabinet, opposite side. Invert and install upper hinge on door. Environmental Requirements The surrounding air temperature must be at least 50°F (10°C) but must not exceed 110°F (40°C). Units may be installed outdoors in a covered area. Carefully examine the door's gasket to assure that it is firmly in contact with the cabinet. Note: When inspecting door alignment, make sure the door gasket is not pinched on the hinge side of the door. If the door is properly aligned, go on to 6 Prepare Plumbing. If it is not, use the following procedure. WARNING To prevent accidental electrocution, make certain that the floor surfaces surrounding the unit are dry whenever power is removed from, or applied to, the unit. Water Supply Connection When connecting the water supply, follow these guidelines: · Review the local plumbing codes before you install the unit. · Connect to the cold water supply. · The water pressure should be between 20 and 120 psi. · Install a shut-off valve in the 1/4 inch OD water supply line. · Connect sufficient tubing to the unit so that tubing may be looped, allowing the unit to be removed for cleaning and servicing (see Figure 18). However, make certain that the tubing is not pinched or damaged during installation. · U-Line recommends the use of copper tubing for installation. Install the 1/4 inch OD copper water line from the main water source. Adjusting Door Alignment 1. [. . . ] Place the two hook-hinges (located on the rear bottom side of the grille) onto the front lip of the unit base. Swing the grille up into position, aligning the grille screw hole on the grille to the grille screw hole on the cabinet. See Figure 22. www. U-LineService. com 10 02/2005 CO29A and CO29FF Ice Maker/Refrigerators 10 Start-Up for the First Time Grille Hook-Hinge Unit Base Front Lip Initial Start-Up The unit is shipped with the control preset to a mid-point setting between 4 and 5. Assure that setting was not altered in shipment. [. . . ]