User manual WHIRLPOOL WRS322FNAM INSTALLATION GUIDE

[. . . ] 35 W10436749C REFRIGERATOR SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] If the gray water tube supplied with the refrigerator is not long enough, a ¹⁄₄" x ¹⁄₄" (6. 35 mm) coupling is needed in order to connect the water tubing to an existing household water line. Thread the provided nut onto the coupling on the end of the copper tubing. Then tighten it with a wrench two more turns. Remove and discard the short, black plastic part from the end of the water line inlet. Thread the nut onto the end of the tubing. Then tighten it with a wrench two more turns. NOTE: To avoid rattling, be sure the copper tubing does not touch the cabinet’s side wall or other parts inside the cabinet. Tighten any nuts or connections (including connections at the valve) that leak. Install the water supply tube clamp around the water supply line to reduce strain on the coupling. Tighten any connections (including connections at the valve) or nuts that leak. Remove and discard the plastic part that is attached to the inlet of the water valve. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Use the tube clamp on the back of the refrigerator to secure the tubing to the refrigerator as shown. This will help avoid damage to the tubing when the refrigerator is pushed back against the wall. Tighten any connections (including connections at the valve) or nuts that leak. electrical Shock Hazard Plug into a grounded 3 prong outlet. Failure to follow these instructions can result in death, fire, or electrical shock. See “Water and Ice Dispensers” in the User Instructions or User Guide. NOTE: Allow 24 hours to produce the first batch of ice. Allow 72 hours to completely fill ice container. Be sure to replace the bulb with one of the same size, shape and wattage. [. . . ] The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42 and 53. –  It is important that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised. Property damage can occur if all instructions are not followed. Prices are subject to change without notice. [. . . ]