User manual WHIRLPOOL WRS325FDAB WARRANTY INFORMATION

[. . . ] 14 Maintenance and Cleaning Removal and Replacement Service Diagnosis . 32 Parts lists and wiring diagrams are in the center of this manual, printed on yellow paper. This manual was printed on recycled paper. Note the Warning symbol where it appears, it marks a possible hazard. January 1994 Page 1 WRS325FDAB & FME2400 FOR THE INSTALLER BACK VIEW The FME2400 and the WRS325FDAB are designed to fit the following Scotsman storage Condenser Inlet (W/C): 3/8" FPT bins: B90 and extensions (with bin top KBT18) BH800 no bin top required. 9. 5" 5. 25" BH900 using bin top KBT14. [. . . ] Clean the condenser; reassemble by placing the fan motor assembly onto the locating pins, replacing the mounting screws, plugging the fan motors back in, and replacing the top panel. Reconnect power. January 1994 Page 18 WRS325FDAB & FME2400 MAINTENANCE AND CLEANING: Auger In some areas the water supply to the ice maker will have a great deal of minerals in it, and that will result in an evaporator and auger becoming coated with these minerals, requiring a more frequent removal than twice per year. If in doubt about the condition of the evaporator and auger, the auger can be removed so the parts can be /////////////WARNING/////////////// inspected. The auger has sharp Note: Water filters can filter out suspended solids, edges, handle with care. ``Soft'' water may not be //////////////////////////////////////////// the complete answer. Check with a water treatment specialist regarding water treatment. For more information on removal of these parts, see REMOVAL AND REPLACEMENT. ALLEN SCREWS BREAKER & BEARING & AUGER ASSEMBLY Disconnect electrical power before beginning. 1. To remove the auger, remove the front and top panels. Push back bail clamp holding ice chute cover to ice chute, and remove cover. Loosen band clamp under ice chute, and remove ice chute from evaporator. 5. Remove 4 allen screws holding breaker to evaporator. Clean the condenser and (if used) the filter. If the air flow is poor because of the installation, advise the user that the unit should be moved, or the air around it kept cooler. Check the fan motor for tight bearings and proper rotation. Check that the fan blades are clean, and the fan secure to the fan motor shaft. The machine will not run if there is not enough water in the reservoir. See the next step. January 1994 Page 20 WRS325FDAB & FME2400 SERVICE DIAGNOSIS: Condition - No Ice Being Produced STATUS: NOTHING OPERATES G. Check: The gear motor , if it will not run, the compressor will not run. If no power to it: Check: The indicator lights on the circuit board, the bin empty light should be ON, the no water light should be OFF . If the bin empty and no water lights are off, check the transformer . Transformer ``load'' side should have 12 to 15 volts. If not, check the ``line'' side. [. . . ] When one of these refrigeration systems is opened for service, it must be re-sealed as soon as possible (15 minutes maximum). ·Special leak detection equipment is required to locate small refrigerant leaks. Usually a leak detector capable of detecting a Halongenated refrigerant or HFC-134a will work. Check with the leak detector manufacturer if in doubt. Access Valves: To use the access valves: ·Remove the cap from the stem, use a 3/16" allen wrench to check that the valve is CLOSED. [. . . ]