User manual WHIRLPOOL WRS325FNAE ENERGY GUIDE

[. . . ] The sink may be retained, or removed and the optional longer splash panel (KSP1B) installed in place of the original. Instructions for each kit are included in this manual. Before beginning the installation, check that all the materials and kits required are available at the installation location. 3. 54" 20. 5" 4. 5" ELECTRICAL JUNCTION BOX NAMEPLATE on side panel 2. 56" 14. 06" 1. 88"dia 3/8" FPT Condenser Water Inlet (Water Cooled) 3/8" Flare Potable Water Inlet Optional for water and drain lines 22. 5" 5. 12" Serial Number Plate inside on upper base 1/2" FPT Cond. Drain (Water Cooled) 3/4" FPT Drain 12. 27" 3. 12" 1. 12" 6. 43" SPECIFICATIONS Model Number Dimensions w" x d" x h" NDE554AS-1A NDE554WS-1A NDE554AS-6A NDE554WS-6A WRS325FNAEAS-1A WRS325FNAEWS-1A WRS325FNAEAS-6A WRS325FNAEWS-6A Condenser Basic Electrical Min. [. . . ] The water should be between 90-115 degrees F. Scotsman Ice Machine Cleaner contains acids. In case of external contact, flush with water. Keep out of the reach of children. 9. As the ice maker begins to use water from the reservoir, continue to add more cleaning solution to maintain a full reservoir. After all of the cleaning solution has been added to the reservoir, and the reservoir is nearly empty, switch the master switch to OFF. After draining the reservoir, as in step 6, wash and rinse the water reservoir. To Sanitize: Repeat steps 8-11, only use an approved sanitizing solution in place of the cleaning solution. A possible sanitizing solution to use could be 1 ounce of household bleach mixed with 2 gallons of warm (95oF. Remove the block from the float in the water reservoir. Continue ice making for at least 15 minutes, to flush out any cleaning solution. Check ice for acid taste - continue icemaking until ice tastes sweet. "Soft" water may not be the complete answer. Check with a water treatment specialist regarding water treatment. For more information on removal of these parts, see REMOVAL AND REPLACEMENT. To remove the auger, remove the front and top panels. Push bail clamp off of cover and remove cover. Remove 4 allen screws holding breaker to evaporator. After the auger has been removed, allow the auger to dry: if the auger is not bright and shiny, it must be cleaned. Clean the auger and evaporator as required. Reverse to reassemble. ALLEN HEAD SCREWS BREAKER AND AUGER ASSEMBLY March 2000 Page 20 SERVICE DIAGNOSIS: Symptom No ice is made, nothing operates Possible Cause Unit off due to no power Unit off due to master switch in OFF position. Unit off due to low water level. NDE554 & WRS325FNAE Probable Correction Restore Power Switch master switch to ON. Check water supply, filter, strainer, float valve. Check/clean ice level sensors. No ice, auger motor is turning Unit off due to ice level sensors (photo-electric eyes) blocked. [. . . ] A) Remove the cap screws holding the gearmotor case halves together and pry the two cases apart. B) To lift off the cover, lift up until you can feel internal contact, then pull the cover towards the output gear end, and then lift the cover (with drive motor attached) up and away from the gear motor case. Note: The case cover output gear, bearings, and shaft are one pressed together assembly. C) Inspect the oil, gears, and bearings. [. . . ]