User manual WHIRLPOOL WRS325FNAH WARRANTY INFORMATION

[. . . ] 8 Start Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Service Diagnosis Removal and Replacement Reservoir and Bin Controls . 32 Parts lists and wiring diagrams are in the center of this manual, printed on yellow paper. August 1993 Page 1 WRS325FNAH FOR THE INSTALLER BACK VIEW The WRS325FNAH is designed to fit the following Scotsman storage Condenser Inlet (W/C): bins: 3/8" FPT B90 and extensions (with bin top KBT18) BH800 no bin top required. 9. 5" 5. 25" BH1360, no bin top required. [. . . ] Check with a water treatment specialist regarding water treatment. For more information on removal of these parts, see REMOVAL AND REPLACEMENT. WARNING Shut off electrical power and water supply. To remove the auger, remove the front and top panels. Remove 3 hex studs holding ice chute cover to ice chute, and remove cover. Loosen band clamp under ice chute, and remove ice chute from evaporator. Remove 4 allen screws holding breaker to evaporator. Drain the evaporator by pulling down and uncapping the evaporator drain tube. ALLEN SCREWS BREAKER & BEARING & AUGER ASSEMBLY 7. After the auger has been removed, allow the auger to dry: if the auger is not bright and shiny, it must be cleaned. Clean the auger and evaporator as required. Reverse to reassemble. August 1993 Page 19 WRS325FNAH SERVICE DIAGNOSIS: Condition - No Ice Being Produced STATUS: NOTHING OPERATES A. It opens from excess pressure of ice inside the ice chute: this should only happen when the machine does not shut off when the ice storage bin is full. The machine will not run if there is not enough water in the reservoir. See the next step. August 1993 Page 20 WRS325FNAH SERVICE DIAGNOSIS: Condition - No Ice Being Produced STATUS: NOTHING OPERATES H. Check: The gear motor, if it will not run, the compressor will not run. If no power to it: Check: The indicator lights on the circuit board, the bin empty light should be ON, the no water light should be OFF . If the bin empty and no water lights are off, check the transformer. Transformer "load" side should have 12 to 15 volts. If not, check the "line" side. The line side should have between 208-230 volts. If the line side has the correct voltage and the load side does not, replace the transformer. If the transformer is good, and the bin empty light is OFF, check the ice level sensors. [. . . ] Although pressure readings may be taken with the valve cracked open, several turns are required to completely open the valve. Close the valve and replace the caps when the job is finished. ALLEN WRENCH Torque Stem to 6-8 ft. lb. . · If gauges must be used, do not always check the high side pressure. If the condenser is clean and seems to be operating correctly, it most likely is. [. . . ]