User manual WHIRLPOOL WRS342FIAB WARRANTY INFORMATION

[. . . ] Improper hook-up can result in substantial property damage!If you are unsure of your ability to safely connect the water supply to the unit, consult a licensed plumber for assistance. · This unit requires connection to a grounded (threeprong), polarized receptacle that has been placed by a qualified electrician in accordance with applicable electrical codes. Safety Alert Definitions Safety items throughout this guide are labeled with a Danger, Warning or Caution based on the risk type: DANGER Danger means that failure to follow this safety statement will result in severe personal injury or death. WARNING Warning means that failure to follow this safety statement could result in serious personal injury, or death. CAUTION Caution means that failure to follow this safety statement may result in minor or moderate personal injury, property or equipment damage. www. U-LineService. com 2 02/2005 BI-95 Ice Maker General Precautions Use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide: 2 Inspect and Plan You have received a carton containing your BI-95 Ice Maker with a package inside containing a User Manual, a Product Registration Card and water connection parts. Complete and mail the Product Registration Card or register online at www. U-LineService. com. [. . . ] Remove screws on opposite side of cabinet (Figure 6). Note that there may be a nut behind one or both screws on either side. Figure 9 7. Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge. Remove three plastic screw plugs from hinge holes, top of cabinet, opposite side. Invert and install upper hinge on door. Figure 10 Figure 6 Figure 7 4. Install hinge on opposite side, bottom of cabinet. Replace nut on back side where installed. Align hinge outer edge with cabinet before tightening screws. 02/2005 5 www. U-LineService. com BI-95 Ice Maker 10. Fasten upper hinge to unit (three screws). Tighten upper and lower hinge screws securely. Replace three plastic plugs removed in Step 8 into holes on top of unit. Place door on bottom hinge pin and install upper hinge screw. Note: When inspecting door alignment, make sure the door gasket is not pinched on the hinge side of the door. If the door is properly aligned, go on to 6 Prepare Plumbing. If it is not, use the following procedure. Figure 12 Figure 13 Adjusting Door Alignment 1. Loosen (do not remove) top and bottom hinge screws. Make sure gasket is firmly in contact with cabinet all the way around the door (no gaps). Figure 15 Figure 14 02/2005 7 www. U-LineService. com BI-95 Ice Maker 6 Prepare Plumbing CAUTION Plumbing installation must observe all state and local codes. All water connections MUST BE made by a licensed/ qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm. Water Line WARNING To prevent accidental electrocution, make certain that the floor surfaces surrounding the unit are dry whenever power is removed from, or applied to, the unit. Figure 16 Figure 17 Water Supply Connection When connecting the water supply, follow these guidelines: · Review the local plumbing codes before you install the unit. · Connect to the cold water supply. · The water pressure should be between 20 and 120 psi. [. . . ] Normal operation creates some vibration. A water supply line contacting an internal component or cabinet wall can cause excessive noise during operation or damage to the line. For recessed installations, allow extra water supply line length to provide slack for easy removal from the recessed area (see Figure 18). This will also safeguard against kinking the line. [. . . ]