User manual WHIRLPOOL WRS965CIAH ENERGY GUIDE

[. . . ] · This unit requires connection to a grounded (threeprong), polarized receptacle that has been placed by a qualified electrician in accordance with applicable electrical codes. Safety Alert Definitions Safety items throughout this guide are labeled with a Danger, Warning or Caution based on the risk type: DANGER Danger means that failure to follow this safety statement will result in severe personal injury or death. WARNING Warning means that failure to follow this safety statement could result in serious personal injury, or death. CAUTION Caution means that failure to follow this safety statement may result in minor or moderate personal injury, property or equipment damage. www. U-LineService. com 2 02/2005 15R and 15WC Models General Precautions Use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide: 2 Inspect and Plan You have received a carton containing your 15R Refrigerator or 15WC Wine Captain® with a package inside containing a User Manual and a Product Registration Card. Complete and mail the Product Registration Card or register online at www. U-LineService. com. Once your unit is installed, keep the User Manual and this Installation Guide in a safe place for future reference. 15R units are available in Black vinyl clad cabinets with matching doors and in Stainless models with a stainless steel door panel, brushed aluminum doorframe and handle, and a black cabinet. [. . . ] To reverse the door on Black 15R Refrigerator models: 1. Remove top hinge from cabinet (three screws). Lift the door off the bottom hinge. 5. Relocate plastic spacer/ bushing on bottom of door to opposite side, and place door on bottom hinge pin. Clean out bushing hole in door bottom with a screwdriver if necessary. Remove plastic hole plug from door handle and relocate on opposite side. See Figure 9. Bushing Figure 8 Hinge Plastic Plug Hole Plastic Plug Hole Screw Right Side Door Swing Right Side Hinge Invert Screw Invert Hinge Left Side Door Swing Figure 4 Figure 5 Figure 9 7. Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge. Remove three plastic screw plugs from hinge holes, top of cabinet, opposite side. Invert and install upper hinge on door. 3. Remove bottom hinge from cabinet (two screws). The unit must not be located near heat-generating equipment or in direct sunlight. Figure 12 4. Remove bottom hinge bracket from cabinet (two screws). Remove screws on opposite side of cabinet (Figure 6). Note that there may be a nut behind one or both screws on either side. Install hinge bracket on opposite side, bottom of cabinet. Replace nut on back side where installed. Align hinge outer edge with cabinet before tightening screws. Remove the top pivot plate from the door (two screws). Invert and install it on the bottom of the opposite side of the door. Bushing Pivot Plate Door Figure 13 02/2005 7 www. U-LineService. com 15R and 15WC Models Side-By-Side Installation Instructions For a complete refreshment center, install two of the 15 series units side by side: 15R and 15WC. · Cut-out width for a side-by-side installation is the total of the widths listed under Cut-Out Dimensions in each unit's Installation Guide. For example: Placing a 15R next to a 15WC would require a cut-out width of: 15-3/16" + 15-3/16" = 30-3/8" · No trim kit is required. [. . . ] · Never use an extension cord to connect power to the unit. Check the levelness after each adjustment and repeat the previous steps until the unit is level. Go on to 8 Install the Unit. Installation Tip If the room floor is higher than the floor in the cut-out opening, adjust the rear feet to achieve a total unit rear height of 1/8" less than the opening's rear height. Shorten the unit height in the front by adjusting the front feet. [. . . ]