User manual WHIRLPOOL WRT108FZDW INSTALLATION GUIDE

[. . . ] COUVERTURE ARRIÈRE W10728576A REFRIGERATOR SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] Using a hex-head socket wrench, remove the three ⁵⁄₁₆" hex-head hinge screws from the top hinge and lift up to remove the hinge. NOTE: Provide additional support for the doors while the hinges are being moved. Do not depend on the door magnets to hold the doors in place while you are working. Lift the freezer door off of the center hinge and set it aside. 6 Reverse Freezer Door Reverse Doors and Hinges (optional) IMPORTANT: If you want to reverse your doors so that they open in the opposite direction, follow these steps. If you are not reversing the doors, see “Replace Doors and Hinges. € See complete graphics later in these instructions. Using the screw removed earlier, fasten the door stop to the bottom of the freezer door. Depending on your model, place the handle on the shoulder screw and push the handle toward the door until the mounting base is flush against the door. Remove the plug covering the hole on the opposite side of the door, where the refrigerator door handle will be installed, and discard the hole plug. Depending on your model, remove the shoulder screw and its washer from the left-hand side of the door and fasten it into the hole that was behind the cap. Depending on your model, place the handle on the shoulder screw and push the handle toward the door until the mounting base is flush against the door. Fasten the top of the refrigerator handle to the top of the refrigerator door. Fasten the bottom of the handle to the bottom of the freezer door. Set aside the freezer door until the hinges and refrigerator door are in place. Remove the door stop from the bottom of the refrigerator door. Replace the door stop on the opposite side of the refrigerator door, making sure that the hole in the door stop plate is aligned perfectly with the hole for the bottom hinge pin. See the model specific graphics later in these instructions. door Handles Installed with Flat-head Screws and Setscrews ■ ■ ■ 9. Cover the remaining hole with the hole plug (provided). Remove the screws from the top of the refrigerator door handle. Remove the setscrew from the lower part of the handle. [. . . ] Ice crystals inside a sealed package are normal. This simply means that moisture in the food and air inside the package have condensed, creating ice crystals. Put no more unfrozen food into the freezer than will freeze within 24 hours (no more than 2 to 3 lbs of food per cubic foot [907 to 1, 350 g per L] of freezer space). Leave enough space in the freezer for air to circulate around packages. [. . . ]